Loading ...
Loading ...
Loading ...
13
Electric models - U.S. only
The dryers require a 120/240 volt, 60Hz AC approved electrical service.
The electric service requirements can be found on the data label located on the back.
A 30-amperefuse or circuit breaker on both sides of the line is required.
- If a power cord is used, the cord should be plugged into a 30-ampere receptacle.
- The power cord is NOT provided with U.S. electric model dryers.
RISK OF ELECTRIC SHOCK:
When local codes allow, the electrical supply of the dryer may be connected by
means of a new power supply cord kit, marked for use with a dryer, that is UL
listed and rated at a minimum of 120/240 volts, 30-ampere with three No. 10
copper wire conductors terminated with closed loop terminals, open-end spade
lugs with turned up ends, or with tinned leads.
- Do not reuse a power supply cord from an old dryer. The power cord electric
supply wiring must be retained at the dryer cabinet with a suitable UL-listed
strain relief.
- Grounding through the neutral conductor is prohibited for (1) new branch-
circuit installations, (2) mobile homes, (3) recreational vehicles, and (4) areas
where local codes prohibit grounding through the neutral conductor. (Use a
4-prong plug for 4 wire receptacles, NEMA type 14-30R.)
WARNING
An individual branch (or separate) circuit serving only your dryer is recommended.
DO NOT USE AN EXTENSION CORD.
Electrical connections
Electric models - Canada only
- A 120/240 volt, 60Hz AC approved electrical service fused through a 30-ampere
fuse or circuit breaker on both sides of the line is required.
- All Canadian models are shipped with the power cord attached. The power cord
should be plugged into a 30-ampere receptacle.
Note: A power cord is NOT provided with U.S. electric model dryers
INSTALLATION REQUIREMENTS
Loading ...
Loading ...
Loading ...