Loading page 1...
Loading page 2...
Loading page 3...
Loading page 4...
Loading page 5...
Loading page 6...
Loading page 7...
Loading page 8...
Loading page 9...
Loading page 10...
Loading page 11...
Loading page 12...
Loading page 13...
Loading page 14...
Loading page 15...
Loading page 16...
Loading page 17...
Loading page 18...
Loading page 19...
Loading page 20...
Loading page 21...
Loading page 22...
Ice maker is not
making enough ice.
PROBLEM 1 CAUSE
A UTOMA TIC ICE MAKER (CONTINUED)
• Ice maker is producing less ice
than you expect.
Ice maker will not stop
making ice.
Ice maker is not
separating the ice
cubes.
Ice has bad odor and
taste.
• Freezer is not cold enough
• Household water line valve is
not completely open
• Check to see if water
dispenser is dispensing slower
than normal
Ice maker wire signal arm is
being held down by some item
in the freezer
• Ice cubes are not being used
frequently enough
• Ice cubes are hollow or smaller
than normal
• Ice has picked up odor or
flavor from strong food stored
in refrigerator or freezer
• Water running to ice maker
has poor taste or odor
• Ice not used frequently enough
ICE DISPENSER
J CORRECTION
Ice maker should produce approximately 4 - 5 pounds
of ice every 24 hours Extra Ice should produce up to 8
pounds of ice every 24 hours
See PROBLEM section TEMPERATURES ARE TOO
WARM.
Turn on household water line valve
If it is, replace the ice & water filter cartridge
• Move item and release wire signal arm Remove any
ice cubes that are frozen together over the wire signal
arm
• Remove and shake ice container to separate cubes
• The ice & water filter cartridge may be clogged
Replace filter cartridge
• Cover foods tightly Discard stale ice Ice maker will
produce fresh supply.
• Add filter to water supply line Consult a water
purifying company
• Discard stale ice
Dispenser will not
dispense ice.
Ice dispenser is
jammed.
Ice storage container is empty
Freezer temperature is set too
warm
Household water line valve is
not open.
Freezer door is not closed
Ice dispensing arm has been
held in for more than 4-5
minutes
• Ice has melted and frozen
around auger due to infrequent
use, temperature fluctuations,
and/or power outages
• Ice cubes are jammed
between ice maker and back
of ice container
• Ice cubes are frozen together
Ice cubes are hollow or smaller
than normal.
• When the first supply of ice is dropped into the
container, the dispenser should operate
• Turn freezer control to a higher setting so that ice
cubes will be made. When first supply of ice is made,
dispenser should operate.
• Open household water line valve Allow sufficient time
for the ice to be made. When ice is made, the
dispenser should operate
• Ensure freezer door is closed
• Motor is overloaded. Motor overload protector will
reset in approximately 3 minutes Ice can then be
dispensed.
• Remove ice container, thaw, and empty the contents
Clean container, wipe dry, and replace in proper
position When new ice is made, dispenser should
operate
• Remove ice cubes that are jamming the dispenser.
Use the dispenser often so that cubes do not freeze
together
The ice & water filter cartridge could be clogged.
Replace the filter cartridge. Dispensing system
operates best at 30 - 100 psi water pressure Well
water pressures should fall within this range
23
Loading page 24...