WRS26MF5ASL White-Westinghouse refrigerator

User Manual - Page 5

For WRS26MF5ASL.

PDF File Manual, 24 pages, Download pdf file

Loading page 1...
Loading page 2...
Loading page 3...
Loading page 4...
background
Before lnstafling The Water Supply Line, You Will Need:
,, Basic Tools: adjustable wrench, flat-blade screwdriver,
and Phillips TM screwdriver
,, Access to a household cold water Iine with water pressure
between 30 and 100 psi.
,, A water supply line made of ¼ inch (6.4 ram) OD, copper
tubing. To determine the length of copper tubing needed,
you wilI need to measure the distance from the ice maker
inlet valve at the back of the refrigerator to your cold water
pipe. Then add approximately 7 feet (2.1 meters), so the
refrigerator can be moved out for cleaning (as shown).
,, A shutoff valve to connect the water supply Iine to your
household water system. DO NOT use a self-piercing type
shutoff valve.
,, A compression nut and ferrule (sleeve) for connecting the
water supply line to the ice maker inlet valve.
To Connect Water Supply Line To lee Maker Inlet Valve
1. Disconnect refrigerator from electric power source.
2. Place end of water supply line into sink or bucket. Turn ON
water supply and flush supply Iine until water is clear. Turn
OFF water supply at shutoff valve.
3. Unscrew plastic cap from water valve inlet and discard
cap.
4. Slide brass compression nut, then ferrule (sleeve) onto
water supply line, as shown.
5. Push water supply line into water valve inlet as far as it will
go inch). Slide ferrule (sleeve) into valve inlet and
finger tighten compression nut onto valve. Tighten another
half turn with a wrench; DO NOT over tighten.
6. With steel clamp and screw, secure water suppiy line to
rear panel of refrigerator as shown.
7. Coil excess water supply line (about 2_/2turns) behind
refrigerator as shown and arrange coils so they do not
vibrate or wear against any other surface.
8. Turn ON water suppiy at shutoff valve and tighten any
connections that leak.
9. Reconnect refrigerator to electrical power source.
10. To turn ice maker on, lower wire signal arm (side
mounted) or set the ice maker's On/Off power switch to the
"t" position. (rear mounted)
Plastic Water Tubieg
to Ice Maker
I_ Fill Tube
water he
Water Valve
Valve Inbt
valve
-ousehold water suppl_
(Include enough tubing _nIoos to allow
rnowng retngerator out fox cleaning.,
Loading page 6...
Loading page 7...
Loading page 8...
Loading page 9...
Loading page 10...
Loading page 11...
Loading page 12...
Loading page 13...
Loading page 14...
Loading page 15...
Loading page 16...
Loading page 17...
Loading page 18...
Loading page 19...
Loading page 20...
Loading page 21...
Loading page 22...
Loading page 23...
Loading page 24...