Loading ...
Loading ...
Loading ...
ge.com
Fan Switch
To reach tile tim switch (es) remove tile
fl'ont grille.
OnHea_/Cooland Heat Pump models, tile tim switch
levex_ are located in holes accessed through tile
control box. Tile top switch is fin _COOLsettings
and tile bottom sMtch is fin" HEATsetfings.
Use a small screwdriver to change the setting.
The trait is shipped fl'om the thctory set in the
CONTsetting tot COOLand in tile cgCtfsetting
fi)r HEAT
Coolonly models have a rocker switch on tile
front of the control box.
_,_]_en set at CYCLE(down) tile tim cycles on and
off when cooling. When set at CONT(continuous,
up) tile tim runs all tile time, providing a more
balanced mmperamre. Tile trait is shipped in
the CONTsetting.
Temperature Limiting
Limiting the maMmum and minimum settings
prevents use_ ti'om turning the control to the
extreme heat or cool positions.
The n(mnal range of the temp control is
approximately 60°F to 85°E The control range
may be narrowed by the use of the temperatm'e
limiting screws located behind the control panel.
• •
® •
®
Limits@ Limits
heat cool
temp temp
Eachposition equals approximately 3°E
Vent Control
Tile vent control is located behind tile ti'ont
grille on the fight side of the air discharge area.
X_lell set at CLOSE,onl) the air inside the roonl
will be circulated and conditioned. When set at
OPEN,soine inside air is exhausted outside.
To open or close tile vent:
1. Remove the front grille.
2. Remove the vent card screw.
3. Remove vent card, mrn it over and replace
it by locating rear hole in card over locating
pin inside air discharge and reattaching
ScI'eW _lt [i'OIlt.
Ti_eunitleavesthefactorysetattheCLOSEposition.
_hole
OPENposition
(Meshendtowardhack)
Screwhc
CLOSEposition
(Meshendtowardfront)
A# Direction
Horizontal h)m e_
(m tile fl'ont grille
let you control the
air di*ection up
and down.
Remox e tile fl'ont
grille to ac!iust tile
vexlical loux ers
side-to-side to
direct tile air left
(>r fi ,ht
9
Loading ...
Loading ...
Loading ...