GE - General Electric AJES10DCCW2 GE room air conditioner

User Manual - Page 22

For AJES10DCCW2.

PDF File Manual, 24 pages, Download pdf file

Loading ...
Loading ...
Loading ...
Before youcall forservice...
Troubleshooting -tips: Save time and money! Review the chart below first and you may not need to call for service.
Possible Causes What ToDo
Airconditioner
doesnotstart
Make sure tile air conditioner plug is pushed
completel} into tile outlet.
The air conditioner
is unplugged.
The fuse is bloom/circuit (_heck tile house filse/circuit breaker box mid
breaker is tripped, replace the fuse or reset tile breaker.
Power failure. If power thilure occttrs, turn the air conditioner
OFF.V_hel/power is restored, \vail 3 minutes to
restart tile air conditioner to prevent tripping (,t
the COl//})ressof oxerload.
The current interrupter Press the RESErbutton located on the po\_er cord plug.
device is tripped. If the RESETbutton \dll not ,stay,eng;_,g>ed,.... discontinue use
of tile air conditioner and contact a qualified selaice
technician.
Air conditionerdoes Airflow is restricted. Make sure there are no curtains, blinds or tim/iture
notcoolas#should bh)cking the fi'ont of the air conditionel:
The temp control may On models \dth touch pads: In COOLmode, press tile
not be set correctly. DECREASETpad.
On models \dth comrol knobs, tttrn tile temperature
knob to a higher number.
The air f'dter is dirty. *Cle;m the filter at least e_erv 30 days.
See the Oporotiw Instructiot{s secti()ll.
The room may have been hot. _'_]/en tile air conditioner is first turned on, }ou need
to allo\_ time for the roO1Tl tO CO01 do\\l/.
Cold air is escaping. Check for oI3ell film;ice registers,, and cokl air returns.
Set the air conditioner's vent to the closed position.
Coolhlg coils have iced up. See "Air conditioner freezing up" belo\v.
Airconditioner Ice blocks the airflow On models \dth comrol knobs, set the mode control
freezingup mid stops the air conditioner at HIGHFANor HIGHCOOLwith the temp at WARMER.
from cooling the room. ()n models \dth touch pads, set the controls at HIGHFANor
HIGHCOOLand set the thermostat to a higher temperature.
Theremotecontrolis The batteries are inserted Check tile p(,sition of the batteries. Thin should be
not working incorrectly, inserted correctly.
The batteries may be dead. Replace the batteries.
Waterdripsoutside Hot, humid weather. This is hernial.
Water drips indoors The air conditioner is not For proper "_\ater disposal, make sure tile air con(litioner
tilted to the outside, slants slightly fi'orrl tile case ti'ont to tile real'.
Watercollectsin Moisture removed from air This is ,oma;fl for a short period ill areas \_ith little
basepan and drains into base pan. humidity; normal tbr a longer period in _erv humid areas.
Normal Operating Sounds
22
Y)u rnm Ileal" a pinging noise caused b} \_ter being
picked ilI) and thro\_/ag_dnst the condenser on
rainy &its or when the humidit_ is higJl. This
design teatnre helps remove moisture and
improve etticiency.
_bu rna_ hear the tlmnnostat click when the
compressor cycles on and off"
V_ter x_illcollect in tile base )an (turin > hioh
humidit_ or (m rainy days. The water may overflow
and drip from tile outdoor side of the trait.
Tile fan may run exen when the compressor
does llot.
Loading ...
Loading ...