Loading ...
Loading ...
Loading ...
,Operation
Stopping the Tractor & Engine
1. Return the ground speed control(s) to neutral.
2. Disengage the PTO and wait for all moving parts to
stop.
3. Move the throttle control to SLOW position and turn the
ignition key to OFF. Remove the key.
Driving the Tractor
1. Sit in the seat and adjust the seat so that you can com-
fortably reach all the controls and see the dashboard
display.
2. Engage the parking brake.
3. Make sure the PTO switch is disengaged.
4. Start the engine (see "Starting the Engine").
5. Disengage the parking brake and release the brake
pedal.
6. Depress the forward ground speed control pedal to trav-
el forward. Release the pedal to stop. Note that the fur-
ther down the pedal is depressed the faster the tractor
will travel.
7. Stop the tractor by releasing the ground speed control
pedals, setting the parking brake, and stopping the
engine (see "Stopping the Tractor & Engine").
Mowing
1. Set the mower cutting height to the desired level and set
the gauge wheels to the appropriate position (if
equipped).
2. Engage the parking brake. Make sure the PTO switch
is disengaged.
3. Start the engine (see "Starting the Engine").
4. Fully lower the mower using the attachment lift lever and
set cutting height.
5. Set the throttle to FULL.
6. Engage the PTO (Mower Deck).
7. Begin mowing.
8. When finished, shut off the PTO and raise the mower
using the attachment lift control lever.
9. Stop the engine (see "Stopping the Tractor & Engine").
WARNING
The engine will shut off if the reverse ground
speed pedal is depressed while the PTO is on and
the RMO has not been activated. The operator
should always turn the PTO off prior to driving on
roads, paths or any area that maybe used by
other vehicles. Sudden loss of drive could create
a hazard.
WARNING
Mowing in reverse can be hazardous to
bystanders. Tragic accidents can occur if the
operator is not alert to the presence of children.
Never activate RMO if children are present.
Children are often attracted to the unit and the
mowing activity,
Mowing in Reverse
If an operator chooses to mow in reverse, the Reverse
Mowing Option (RMO) system can be used. To use the
RMO, turn the RMO key after the PTO is engaged. The
L.E.D. light will illuminate, and the operator can then
mow in reverse. Each time the PTO is engaged the RMO
needs to be reactivated if desired. The key should be
removed to restrict access to the RMO feature.
Attachment Operation in Reverse
If an operator chooses to operate a PTO driven attach-
ment in reverse, the Reverse Mowing Option (RMO) sys-
tem can be used. To use the RMO, turn the RMO key
after the PTO is engaged. The L.E.D. light will illuminate,
and the operator can then operate the attachment in
reverse. Each time the PTO is disengaged the RMO
needs to be reactivated if desired. The key should be
removed to restrict access to the RMO feature.
Pushing the Tractor by Hand
1. Disengage the PTO and turn the engine off.
2. Pull the transmission release (B, Figure 5) back
approximately 2-3/8" (6 cm) to lock into released
position.
3. The tractor can now be pushed by hand.
®
O
DO NOT TOW TRACTOR
Towing the unit will cause transmission dam-
age. • Do not use another vehicle to push or
pull this unit. • Do not actuate the transmis-
sion release valve lever while the engine is
running.
®
Figure 5. Transmission Release Lever & Fuel Tank
14
Loading ...
Loading ...
Loading ...