Loading ...
Loading ...
Loading ...
page 6
7. Canopy Assembly.
8. Blade Assembly.
Locate 15 blade attachment screw/washers
in hardware pack. Slide blade through one
of the narrow, rectangular openings on
motor housing, aligning holes in blade
with holes in blade arm (located on the
underside of the motor housing)--refer to
drawing at right. Insert 3 blade attachment
screws/washers with fingers first and then
tighten screws securely with a Phillips
screwdriver. Repeat procedure for each
remaining blade.
Note: Tighten blade attachment screws
twice a year.
blade
motor housing
blade attachment
screws/washers
blade arm
(inside motor
housing)
Temporarily raise canopy to hanging bracket to
determine which 2 screws in hanging bracket align
with slotted holes in canopy, and then lower
canopy and partially loosen these 2 screws. Remove
the other 2 screws/lock washers and set aside.
Now, lift canopy to hanging bracket again, aligning
slotted holes in the canopy with loosened screws in
hanging bracket. Twist canopy to lock. Re-insert the
other 2 screws/washers and secure all screws with
a Phillips screwdriver.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
screw
antenna
canopy
hanging bracket
slotted
hole
Loading ...
Loading ...
Loading ...