Loading ...
Loading ...
Loading ...
Filter Replacement and Care
CAUTION: To help retard bacteria
growth and keep maximum
efficiency, the filter should be
replaced at least once per season,
or more often under hard water
conditions, Use Kenmore 15508
replacement filter.
WARNING: To reduce the risk of
shock or injury from moving parts,
always unplug humidifier before
removing or replacing any parts,
Replace the evaporative wicking filter
at least once per humidification season
or more depending on water conditions
in your area_
Filter Replacement
1. Unplug humidifier. Before removing
the filter, move the humidifier to an
area not susceptible to water damage.
(i e, kitchen or bath areas).
2. Remove the water bottle and set
aside° Be sure not to bump or damage
the fill valve,
3o The upper housing and the base are
held together by two hooks at the front
of the housing and a flexible snap in
the rear, To remove the housing, press
in on the triangular shaped snap at the
rear of the humidifier, below the cord
exit, while lifting upward, tilting the
upper housing forward to clear the
hooks at the front of the base.
4. Set the upper housing aside.
The filter is now accessible.
5, Take note of the filter position.
Remove the filter. You may want
to clean the base at this time See
the "Cleaning and Maintenance"
section of this manual
6, Install a new filter (15508) into
the base, Position the filter
between the uprights in the bottom
of the base. The filter should be
resting on the floor of the base.
7. Return the upper housing to the
base by first placing the hooks
located near the front of the base
into the mating holes in the upper
housing, Then tilt the upper
housing down towards the base
until the rear snap engages the
main housing
8, Reposition the humidifier to its
operating position,
9, The humidifier is now ready to
be filled for operation.
10
Loading ...
Loading ...
Loading ...