Loading ...
Loading ...
Loading ...
2=
Insert carriage bolt up through slot on tray-frame side and
support leg. Install SMART-MOUNT _ Tray Assembly in Window
1. From inside, place SMART-MOUNT _tray, support legs facing
down, in the window. Match the holes in tray side with the
predrilled holes in windowsill.
2. Using 2 - #10 - 12 x 11/2"slot-head wood screws, secure the
tray frame to the window.
3. Place one end of tray center over carriage bolt.
4=
5=
Then place flat washer, lock washer and hex nut.
NOTE: Do not tighten. The leg must be able to move freely to
adjust angle when installed.
.A
A. Hex nut D. Tray center
B. Lock washer E.Carriage bolt
C. Flat washer
Insert second carriage bolt through tray side and attach other
end of support leg.
NOTE: Do not tighten. The leg must be able to move freely to
adjust angle when installed.
s A
A. #10 - 12x 1_" slot-head wood screws
NOTE: If the exterior of building can be damaged by support
legs, place a board between the wall and support legs.
3. With tray center pushed away from the windowsill, place a
level on the angled edge on top of the tray side. Be sure level
is against notch on tray side.
A B
A.Angled edge on top of the tray side
B. Notch
4=
Adjust SMART-MOUNT _tray until bubble indicates the
angled edge on top of the tray side is level.
IMPORTANT: The tray must slope downward slightly toward
the outside to provide proper drainage for the air conditioner.
A. Hex nut C. Flat washer
B. Lock washer D. Carriage bolt
6. Install support leg on other side.
A. Bubble indicates theangled edge on top of the trayside is level.
B.Place levelon angled edge against notch on trayside.
5. Tighten the hex nut just enough to hold tray center in place.
6. Repeat with other side.
7. Tighten hex nuts securely with 7A6"wrench.
Loading ...
Loading ...
Loading ...