Loading ...
Loading ...
Loading ...
1
0
Smaller ice setting: By pressing the “Clean” (-) button, you can decrease the size of the ice
cubes. The “ICE” LED (green) will flash as you lower the ice size and will finally be blinking at
the setting of smallest ice size.
Larger ice setting: By pressing the “Mode” (+) button, you can increase the size of the ice
cubes. The “BIN FULL” LED (red) will flash as the larger size is set and will blink when the
setting of largest ice size has been reached.
After 10 seconds without any operation, the unit will return to the previous mode.
NOTE: If during the ice size adjustment mode the “BIN FULL”, “ICE” and “HARVEST” LEDS
blink all at once, this indicates that the unit is in the regular (middle) setting of the ice size.
When the machine is in the cleaning stage or ice full stage, the ice size adjustment mode
cannot be accessed
Making Ice
Once the ice maker has been properly installed, it is ready for operation.
Turn on the water tap, let the water trough fill, then set the ON/OFF button to the ON
position
on
the front panel. The ice maker will start working automatically.
After 3 minutes, the machine will automatically switch
to the freeze cycle, and the sound of
water flowing will be heard.
When the batch of ice has been fully formed, ice will automatically be harvested to the ice
storage bin.
When the ice storage bin is full, the sheet of cubes will not fall completely and will hold the
ice-full probe open. The machine stops making ice automatically.
The unit will start making ice again after the ice cubes are removed and the ice-full probe
swings back to operating position.
IMPORTANT:
Never turn the water supply tap off when the ice maker is working.
Never touch evaporator when unit is running.
To promote proper ice formation and reduce melting, keep the ice maker door properly
closed except when taking ice from the unit.
Ice Maker Cycles
Your Ice Maker has two distinct cycles it will run.
Freeze: During the freeze cycle, the compressor is pumping refrigerant, the fan motor is
blowing air, and the water pump is circulating water. When the batch of ice has been fully
formed, the ice maker stops and begins the Harvest cycle.
13
732 S o u t h Racetrack R o a d , Henderson, Nevada 89015
i n f o @ v i n o t e m p . c o m
Loading ...
Loading ...
Loading ...