Loading ...
Loading ...
Loading ...
DGS-1250 Series Gigabit Ethernet Smart Managed Switch Hardware Installation Guide
4
Press and hold the Reset button for less than 5 seconds (release before 5 seconds) to reboot the Switch. All
unsaved configurations will be lost.
Press and hold the Reset button for more than 5 seconds (release between 6 and 10 seconds) to reset the
software configuration of the Switch to the factory default settings. All the port LEDs will light up (solid amber)
for 2 seconds to indicate the start of the factory reset procedure.
LED Indicators
Located on the front panel of this switch are LED indicators: Power, Console, Fan Error, and Link/Act indicators for all
the ports. The DGS-1250-28XMP and DGS-1250-52XMP switches are equipped with Power Max., PoE indicators for
all the ports, and Link/Act and PoE indicators for mode selection.
Figure 1-5 LED indicators for the DGS-1250-28X
Figure 1-6 LED indicators for the DGS-1250-28XMP
Figure 1-7 LED indicators for the DGS-1250-52X
Figure 1-8 LED indicators for the DGS-1250-52XMP
LED
Description
Power
This LED will light solid green after the Switch has been powered on successfully.
This LED will be off when the Switch is no longer receiving power (i.e. powered
off).
Console
This LED will light solid green when the console port is active.
This LED will be off when the console port is not active.
Fan Error
This LED will light solid red when the fan fails.
This LED will be off when the fan is operating normally.
Loading ...
Loading ...
Loading ...