Loading ...
Loading ...
Loading ...
RIPFENCE HOOKOVER
REARRAILHERE
REARRAiL
Fig. 18
TOINSTALLSCALE
INDICATORONLEFTSIDE
RIPFENCE
FRONTRAIL
MOUNTING THE MOTOR AND SWITCH
See Figures 21 and 22.
• Locate the motor and switch assembly, the motor
mounting plate and the following hardware:
4 hex bolts (5/16-18 x 1 in.)
8 flat washers (5/16 in.)
4 lock washers (5/16 in.)
4 hex nuts (5/16-18)
2 hex bolts (5/16-18 x 3/4 in.)
Yellow switch key
Note: Remaining hardware from this bag is used for
installing the belt guard.
• Release the bevel lock handle (front of the cabinet)
and turn the bevel handwheel (right side of the
cabinet) until the blade is fully vertical. Retighten
the bevel lock handle.
• Align the holes in the motor mounting plate and the
motor bracket so the top edges are even. Place a
flat washer on the four 1 in. bolts and insert them
into the holes.
• Install a flat washer, a lock washer, and a hex nut
on each bolt. Hand tighten only. This is the motor
support assembly,
• Center the motor side to side on the motor mount-
ing plate. Tighten the nuts with a 12 mm wrench.
• Insert the two rods on the motor support assembly
into holes in the cradle. Push the motor in as far as
it will go. Thread the two hex bolts into the cradle
to clamp down on the rods. Oo not securely
tighten bolts yet.
3/4in. HEXBOLTS
MOTORSUPPORT
ASSEMBLYROD
MOTOR
MOUNTING
RIPFENCEHANDLE
Fig. 19
ENDCAP
FLATWASHER
ANDLOCK
WASHER
lln. HEXBOLTS
BRACKET
Fig. 20
MOTOR Fig. 21
23 CRAFTSMflN"TABLESAW315.228490
Loading ...
Loading ...
Loading ...