Loading ...
Loading ...
Loading ...
Note: The right side of saw is on your right when
facing the saw, as if you were in normal
operating position.
INSTALLING THE REAR RAIL
See Figures 12, 13, and 14.
,_ WARNING: Front and rear rails must be
carefully aligned to reduce the risk of kickback,
which can cause serious injury.
• From the carton, remove the rear rail pieces and
the following hardware:
6 square head bolts (5/16-18 x 3/4 in.)
6 hex nuts (5/16-18)
6 flat washers (5/16 in.)
Rear rail connector
Right and left end caps for rear rail
2 screws (#8-32 x 1/2 in.) for end caps
SQUARE
HEADBOLT
HEXNUT
REARRAIL
CONNECTOR
Note: Remaining hardware from this hardware bag is
used for installing the front rail and end caps.
• At the back of the table, put the square head bolts
in the holes in the edge of the saw table and the
outer holes in each extension table so the bolt
heads extend outward 1/2 in.
• Under the table, loosely attach the flat washers
and hex nuts onto bolts. Slide the slot on the rear
rail over the bolts. Adjust each bolt to fit the rail
closely to the table.
• Position right rail so that the right hand edge
extends 2-1/2 inches beyond the table extensions.
• Push the right rail against table and tighten each
hex nut with a 12 rnm wrench. If the rail does not
slide easily over the bolts, re-align the table
extensions.
SLOTFORBOLT
TABLEEXTENSION
REARRAIL
SQUAREHEADBOLT
HEXNUT
FLATWASHER Fig. 13
2in.
REARRAILINSTALLED Fig. 14
ENDCAP
Fig. 12
21 I;RRFT|NIIN"TABLESAW315.228490
Loading ...
Loading ...
Loading ...