Loading ...
Loading ...
Loading ...
SQUARINGTHE BLADETO THEMITER
TABLE
See Figures 28 - 30.
[] Unplug the saw.
[] Pul! the saw arm al! the way down and engage the lock
pin to hold the saw arm in transport position.
[] Loosen the miter lock handles.
[] Rotate the miter table until the pointer is positioned
at 0.
[] Securely tighten the miter lock handles.
[] Loosen bevel lock knob and set saw arm at 0 bevel
(blade set 90 to miter table). Tighten bevel !ock knob.
[] Place a combination square against the miter table and
the flat part of saw blade.
NOTE: Make sure that the square contacts the flat part
of the saw blade, not the blade teeth.
[] Rotate the blade by hand and check the blade-to-table
alignment at several points.
[] The edge of the square and the blade should be parallel.
[] If the top or bottom of the blade angles away from the
square as shown in figure 29, adjustments are needed.
[] Using a !0 mm wrench or adjustable wrench, loosen
the lock nut securing positive stop adjustment screw.
Also loosen bevel lock knob.
[] Adjust positive stop adjustment screw to bring blade
into alignment with the square.
[] Retighten bevel lock knob. Next, retighten lock nut
securing the positive stop adjustment screw. Recheck
blade-to-table alignment.
NOTE: The above procedure can be used to check
squareness of the blade to the miter table at both 0
and 45 angles.
FENCE
MITER
TABLE
[VIITER
CO_,_BINATION TABLE
SQUARE
VIEW OF BLADE NOT SQUARE WITH MITER
TABLE,ADJUSTMENTS ARE REQUIRED
BLADE
Fig. 29
POSITIVESTOP
ADJUSTMENT
SCREW FOR
O°ANGLEB
LOCK
NUT(S)
Fig. 30
23
Loading ...
Loading ...
Loading ...