Loading ...
Loading ...
Loading ...
ELECTRONIC OVEN CONTROL
B
Po_y Cooker
Cookies Pizza
E F G
A. RECIPE RECALL TM
B. Slow cooker
C. Display
D. Oven lockout indicator icon
E. Add ! minute
I J K
E Timer
G. Oven light/oven lockout
H. Oven selectors
L LOGICLEAN TM
J. Temperature setting
K. Timed cooking
M N
L. Clock
M. Hour
N. Minute
O. Start
R Stop/clear
When power is first supplied to the appliance, make sure the
surface elements are in the OFF position. Everything on the
display will light up for 3 seconds, then the time will appear on
the display, flashing on and off.
If the time is flashing on and off at any other time, a power failure
has occurred. To stop the flashing, press any key. To reset the
clock, press CLOCK.
When the oven is in use, this display shows time, temperature
and what command pads have been pressed.
When the oven is not in use, the display will show the time of day.
The START pad begins any function. If the START pad is not
touched after touching another pad, "START?" will appear in the
display.
The STOP/CLEAR pad stops any oven function except for the
Clock, Timer and Oven Lockout.
After pressing STOP/CLEAR, the display will show the time of
day or, if the minute timer is also being used, the time remaining.
This is a 12-hour clock and does not show a.m. or p.m.
To Set:
1. Press CLOCK.
2. Press the HOUR/MIN "up" or "down" arrow pads until the
correct time of day shows on the display.
Press CLOCK or START.
Tones are audible signals, indicating the following:
One tone
• Valid pad press
• Oven is preheating, or has been preheated
• Function has been entered
Three tones
• Invalid pad press
• Error
Four tones
• End of cycle
• Reminder, repeating each minute after the end-of-cycle tones
Error Tones
Error tones indicate a problem with the electronic oven control.
An error code will appear in the display.
Tone Volume
The volume can be adjusted between high and low.
To Change: Press and hold DELAY START for 3 seconds. A short
tone will sound, and either "Snd HI" or "Snd Lo" will appear on
the display. Press and hold DELAY START again for 3 seconds to
change to desired setting.
"Snd on," "Snd OFE" "rEP on," "rEP off," "Snd HI" or "Snd Lo"
will disappear from the display after 3 seconds.
10
Loading ...
Loading ...
Loading ...