Loading ...
Loading ...
Loading ...
5 Mostmotortroublesmaybetracedto looseor
incorrectconnections,overload,reducedinput
vottage(suchassmallsizewire inthesupply
circuit) or to overlylong supplycircuit wire
Alwayschecktheconnections,theloadandthe
supplycircuit whenevermotorfails to perform
satisfactorily_Checkwiresizeandlengthwith
theWireSizeChartbelow
WIRE SIZES
The use of any extension cord will cause some loss
of power To keep this to a minimum and to prevent
overheating and motor burn-out, use the table below
to determine the minimum wire size (A.W G.) exten-
sion cord. Use only 3-wire extension cords which
have 3-prong grounding type plugs and 3-pole
receptacles which accepts the tools ptug
CAUTION: For circuits that are farther away from
electrical service box, the wire size must be increased
proportionately in order to deliver ample voltage to
the saw motor.
Length of the 120 Volts Wire Sizes Required
Conductor (American Wire Gage Number)
0 - 25 Ft 16
26 _ 50 Ft 14
51 - t00 Ft. 12
unpacking and checking contents
TOOLS NEEDED
MEDIUM SCREWDRIVER
@
.2PHILLIPSSCR WOR,VER@ @
COMBINATION _("_
SQUARE .i_'
118"' HEX "L'" WRENCH
5/32" HEX "L'" WRENCH
3/8" WRENCH
7/16" WRENCH
9/16'" WRENCH
7/16- SOCKET
9/16" SOCKET
_ SOCKET WRENCH
COMBINATION SQUARE MUST BE TRUE
DRAW LIGHT
LINE ON BOARD
ALONG THIS EDGE "_._,_
LJ
S
SHOULD BE NO GAP OR OVERLAP HERE WHEN
SQUARE tS FLIPPED OVER IN DOTTED POSITION
STRAIGHT EDGE OF
BOARD 3/4=INCH THICK
THIS EDGE MUST BE
PERFECTLY STRAIGHT
WARNING: TO AVOID INJURY FROM UNEXPECT-
ED STARTING OR ELECTRICAL SHOCK, DO NOT
PLUG THE SAW IN UNTIL ALL ASSEMBLY AND
ALIGNMENT STEPS ARE COMPLETE. THE POWER
CORD MUST REMAIN UNPLUGGED WHENEVER
YOU ARE WORKING ON THE SAW.
Unpacking and Checking Contents
t. Separate all "loose parts" from packaging mater-
ials and check each item with "Table of Loose
Parts" to make sure all items are accounted for,
before discarding any packing material
WARNING: IF ANY PARTS ARE MISSING, DO
NOT ATTEMPT TO ASSEMBLE THE BAND
SAW, PLUG IN THE POWER CORD, OR TURN
THE SWITCH ON UNTIL THE MISSING PARTS
ARE OBTAINED AND ARE INSTALLED COR-
RECTLY.
Remove front table and front cover first while
saw is being unpacked,. To remove the front
cover, pull the cover at the neck and underside of
throat area
7
Loading ...
Loading ...
Loading ...