Loading ...
Loading ...
Loading ...
Rocation and function of the electronic indicator system
BATTERY COVER RELEASE SLOTS
A OPEN BATTERY OPEN A
BATTERY COVER
KEY
ELECTRONIC
MEASUREMENT
BEVEL ANGLE KEY
NSION KEY
SPEED KEY {FT. PER MIN_)
DIGITAL READOUT DISPLAY
DIGITAL READOUT DISPLAY
The Liquid Crystal Display, or LCD, on this saw
gives the user the ability to accurately position the
blade and monitor the set-up The three functions
displayed are:
Bevel Angle - Shows the present angle of the blade
to the table The _ keyisusedtosetthezero
degree point
Blade Tension - Displays the blade size for which the
tension has been adjusted.
Blade Speed - Displays the speed of the blade in
surface feet per minute (FPM)
NOTE: The function being displayed is indicated by
an abbreviated name of the function in the left hand
area of the display; either BEV, TEN, or FPM
BATTERY COVER
The Battery Cover covers the battery compartment
To.release the cover, insert a small coin into one of
the release slots and twist Remove the cover
1 Installing the Battery
The battery is supplied with the loose parts It is a
6-volt, type J alkaline battery. Install the battery
with the contact end down and the "+" terminal
towards the left Push the battery down and back
until the top edge of the battery is caught under
the ribs in the compartment Do not force the
battery It if doesn't push in easily, remove the
battery and check that it is positioned correctly.
2.. Reinstall battery covery by inserting the tabs on
the lower edge of the cover into the mounting
holes in the control and pushing the cover into
position
FUNCTION KEYS
The five keys located to the right of the display are
the function keys They are:
_-- Turns the display "On" "Off"
or
_-- Selects the Bevel
Angle display
_-- Selects the Blade Tension display
_-- the Blade Speed display
Selects
_-- Sets the Bevel Angle to Zero
NOTE: In order to extend battery life tha display will
shut off approximately five (5) minutes after the last
key was pressed
17
Loading ...
Loading ...
Loading ...