Loading ...
Loading ...
Loading ...
7 Carefully position the motor so that the poly "V"
belt is around the motor pulley and the four
motor studs align with the slots in the motor
mount
8, Push motor studs through and install theflanged
lock nuts to the three (3) motor studs with
spacers, Start the flanged nuts by hand only at
this time,
SPACER
9, Install the threaded stud through the hole in the
lower teg of the motor mount and over the motor
stud as shown
THREADED STUD
10 Install a flanged lock nut onto this motor stud
Tighten the flanged lock nuts, using a 3/8qnch
wrench, until almost tight
NOTE: Do not over-tighten the flange nuts The
motor should slide in the grooves to allow
tensioning of the belt
\.oTo.MouNTf
1,,,, im
1! Install the wing nut on the threaded stud
12 Check that the poly "V" belt is on both pulleys
being sure that it is centered on each pulley
13 Check that the pulleys are in fine by sighting
down the side of the large pulley to see if it lines
up with the small pulley If the pulleys are not in
line, loosen the set screw holding the pulfey on
the motor shaft and position the pulley A notch
in the small end of the motor support is provided
for access to the set screw and belt,
• SMALL PULLEY
N
/ -.,
FLANGED LOCK NUT WING NUT
12
Loading ...
Loading ...
Loading ...