Loading ...
Loading ...
Loading ...
Surface CeekJng
Lighting Instructions for
Standing Pilot Models
The surface burners on these ranges have standing
pilots that must be lit initially,. To light them:
1. Be sure surface burner control knobs are in the
OFF position_
2. Remove the grates and lift the cooktop up (see the
Lift-Up Cooktop section)..
Surface Burner Controls
Knobs that turn the surface burners on and off are
marked as to which burners they control,. The two
knobs on the left control the left front and left rear
burners. The two knobs on the right control the right
front and right rear burners.
On ranges with sealed burners:
o The smaller burner (right rear position) will give
the best simmer results.
o The right front burner is higher powered than the
others and wilt bring liquids to a boil quicker
(natural gas installations only).
3. Locate the two pilot ports and light each of them
with a match,.
NOTE: if the pilot is too high or tow, you can adjust iL
See the "Adjust the Surface Burner Pilots tf
Necessary" section of the Installation Instructions,.
4. Lower the cooktop. Your surface burners are now
ready for use,.
5. Observe lighted burners, Compare the flames to
pictures in the Problem Solver. If any flame is
unsatisfactory, call for sen/ice._
Lighting instructions for
Electric Ignition Models
Your surface burners are lighted by electric ignition,
eliminating the need for standing pilot lights with con-
stantly burning flames.
In case of a power failure, you can light the surface
burners on your range with a match. Hold a lighted
match to the burner, then turn the knob to the LITE
position. Use extreme caution when lighting burn-
ers this way.
Surface burners in use when an electrical power fail-
ure occurs will continue to operate normally,
The electrode of the spark igniter is exposed..
When one burner is turned to LITE, all the burners
spark° Do not attempt to disassemble or clean
around any burner while another burner is ono An
electric shock may result, which could cause you
to knock over hot cookware.
Before Lighting a Burner
o If drip pans are supplied with your range, they should
be used at all times.
° Make sure all grates on the range are in place before
using a burner.
To Light a Surface Burner
Electric ignition Models
Push the control knob in and
turn it to LITE. You will hear a little
"clicking" noise--the sound of the
electric spark igniting the burner..
After the burner ignites, turn the
knob to adjust the flame size,
Standing Pilot Model:
Push control knob in and turn it to H1 position. The
burner should light within a few seconds.
After the burner ignites, turn the knob to adjust the
flame size_
Flame will be almost horizontal and will lift slightly
away from the burner when the burner is first
turned on, A blowing sound may be heard the first
few seconds. This normal sound is due to improved
injection of gas and air into the burner. Put a pan on
the burner before lighting it, or adjust the flame to
match pan size as soon as it lights, and the blowing
sound will stop.
22
Loading ...
Loading ...
Loading ...