Loading ...
Loading ...
Loading ...
9
English
Repairs
WARNING: To assure product SAFETY
and RELIABILITY, repairs, maintenance and
adjustment (including power cord repairs, and brush
inspection and replacement, when applicable) should
be performed by a CRAFTSMAN factory service center
or a CRAFTSMAN authorized service center. Always
use identical replacementparts.
6. Wind the cutting line onto the spool in the direction of
the arrow on the spool. Make sure to wind the line on
neatly and in layers. Do not crisscross (Fig.T).
7. When the wound cutting line reaches the recesses, cut
the line.
8. Fit the spool onto the trimmer as described in
Replacing theSpool.
CAUTION: Before you begin trimming, only
use the appropriate type of cutting line.
FigT
Rewinding Spool From Bulk Line
(Fig. R, S, T)
(use only .065" [1.65 mm] ROUnD diameter line)
Bulk line is also available for purchase from your local
retailer. nOTE: Hand wound spools from bulk line are likely
to become tangled more frequently than CRAFTSMAN
factory wound spools. For best results, factory wound spools
arerecommended.
To install bulk line, follow the steps below:
1. Unplugtrimmer.
2. Remove the empty spool from the trimmer as described
in Replacing theSpool.
3. Remove any remaining cutting line from thespool.
4. Make a fold at the end of the cutting line at about 3/4"
(19mm)
25
. Feed the cutting line into one of the line
anchoring slots
26
as shown in Fig.R.
Fig. R
26
25
5. Insert the 3/4" (19mm)
25
end of the bulk line into the
hole
26
in the spool adjacent to the slot as shown in
Fig. S. Make sure the line is pulled tight against the spool
as shown in Fig.T.
Fig. S
25 26
Fig. Q
24
Versatrack™ (Fig. U)
WARNING: To reduce the risk of
serious personal injury, turn unit off and
disconnect it from power source and before
making any adjustments or removing/installing
attachments or accessories. An accidental start-up
can causeinjury.
WARNING: To reduce the risk of serious
personal injury, do not use a damaged Versatrack™
integral hang hook or Versatrack™ Trackwall.
A damaged Versatrack™ integral hang hook or
Versatrack™ Trackwall will not support the weight of
thetool.
WARNING: To reduce the risk of serious
personal injury, DO NOT suspend tool overhead or
suspend objects from the integral hang hook. ONLY
suspend tool on the Versatrack™ Trackwall using the
integral hanghook.
Loading ...
Loading ...
Loading ...