Loading ...
Loading ...
Loading ...
English
8
6. Remove any dirt and grass from the spool andhousing.
7. Unfasten the end of the cutting line and guide the line
into the eyelet
23
Fig. P.
Use CRAFTSMAN replacement spool no. CMZST065.
Reload nylon line (either bulk or prewound replacement
spool) as shown in thismanual.
• USE ONLY .065" (1.65 mm) DIAMETER ROUND NYLON
LINE. Do not use serrated or heavier gauge line, as
they will overload the motor and cause overheating.
This line is available at your local dealer or authorized
servicecenter.
• Other replacement parts (guards, spool caps, etc.) are
available through CRAFTSMAN service centers. To find
your local service location call: 888-331-4569 or visit
www.craftsman.com.
Replacing the Spool (Fig. N, O, P, Q)
1. Unplug trimmer.
2. Depress the tabs
18
and remove the spool cap
19
from the spool housing
20
in the trimmer head
(Fig.N).
8. Take the new spool and push it onto the boss in the
housing Rotate the spool slightly until it is seated. The
line should protrude approximately 5-3/8" (136mm)
from thehousing.
9. Align the tabs on the spool cap with the slots
24
in the
housing (Fig.Q).
10. Push the cap onto the housing until it snaps securely
intoplace.
CAUTION: To avoid trimmer damage, if the
cutting line protrudes beyond the trimming blade, cut
it off so that it just reaches theblade.
Accessories
WARNING: Since accessories, other than
those offered by CRAFTSMAN, have not been tested
with this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with thisproduct.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN call 1-888-331-4569.
Fig. N
20
19
18
3. For best results, replace spool with CRAFTSMAN model
no. CMZST065.
4. Grasp empty spool with one hand and spool housing
with other hand and pull spoolout.
5. If lever
21
(Fig. O) in base of housing becomes
dislodged, replace in correct position before inserting
new spool intohousing.
Fig.P
Fig.O
21
23
Loading ...
Loading ...
Loading ...