Loading ...
Loading ...
Loading ...
No meter reading.
1. Connections are reversed.
2. Poor electrical connection.
3. AC outlet is dead.
4. Battery is defective (will not accept
charge).
1. With charger unplugged, reverse
clips and reconnect (rock back and
forth to bite in).
2. Clean clips and battery poles and
reconnect (rollback and forth to
bite in).
3. Plug in a lamp or other appliance
to check for voltage.
4. Have battery checked.
Charger will not taper
down.
Problem Cause Remedy
1. Battery has problem and will not take
full charge.
1. Have battery checked.
1. Battery is defective (will not take a
charge).
1. Have battery checked.
1. Battery is partially charged.
2. Battery is defective (battery plates
are crusted) and will not accept a full
charge.
3. AC power supply is low.
1. Continue charging.
2. Have checked and replace battery.
3. Plug charger into another grounded
AC outlet.
1. Severely discharged battery (but
otherwise good battery)
2. Battery is defective (will not accept
charge).
3. Charger is cycling after circuit
breaking overload.
1. Allow charging to continue until
battery has recovered sufficiently to
take a charge (Circuit breaker will
continue to cycle and needle will
swing side to side until battery has
recovered).
2. Have battery checked.
3. Wait until charger automatically
resets itself.
High meter reading.
Charging current is
less than full out put
rating of charger.
Ammeter needle moves
to extreme right,
remains a short time,
then returns to zero,
accompanied by a
clicking sound.
WARNING: For your safety always turn the main switch on the machine "off" and remove the plug
from the power supply before carrying out any maintenance or trouble shooting.
11. TROUBLESHOOTING
- 21 -
Loading ...
Loading ...
Loading ...