Loading ...
Loading ...
Loading ...
Filter removal and
replacement instructions
Important note: Please ensure you remove the
foam packing under the filter before installing.
1. Remove the front cover (see Diagram 1).
2. Press & hold the ON/OFF button until the
LCD screen says OVERRIDE OFF. Leave the
power supply on.
3. Remove the filter (and filter bypass insert if
required) (see Diagram 2).
a. Hold the bottom of the filter (and filter
bypass insert if required) and pull
towards you slowly. The top of the filter
is a hinged cradle assembly. It should
stop after approximately 30 degrees of
travel.
b. Pull down until it pops out.
4. If water spills in the tray at the base of the
filter, soak it up with a cloth or sponge.
5. If single filter, fit the new filter by
pushing right up into the cradle & pushing
back until it locks into place.
6. Unit will now begin an automatic flush cycle.
7. Check for any leaks from around the filter,
hosing or pipeworks.
8. Replace the front cover.
9. Once the lights stop flashing, your system
is ready to use.
9
User guide
Billi Quadra & Quadra Plus – XL, XT, XR.
Diagram 1
Diagram 2
a
b
Loading ...
Loading ...
Loading ...