Loading ...
Loading ...
Loading ...
STARTING A WARM ENGINE
1. Move ON/OFF switCh to the ON posi-
tion.
2. Move the choke lever to the HALF
CHOKE position.
3. Squeeze and hold the throttle trig-
ger. Keep throttle trigger fully
squeezed until the engine runs
smoothly.
4. Pull starter rope sharply until engine
runs, but no more than 5 pulls.
5. Allow engine to run 15 seconds,
then move the choke lever to the
OFF CHOKE position.
NOTE: If engine has not started, pull
starter rope 5 more pulls. If engine still
does not run, it is probably flooded.
STARTING A FLOODED ENGINE
Flooded engines can be started by
placing the choke lever in the OFF
CHOKE position; then, pull the rope to
clear the engine of excess fuel. This
could require pulling the starter handle
many times depending on how badly
the unit is flooded.
If the unit still doesn't start, refer to
TROUBLESHOOTING TABLE or call
1-800-235-5878.
OPERATING INSTRUCTIONS
It is recommended that the engine
not be operated for longer than 1
minute at full throttle.
OPERATING PosmoN
ALWAYS WEAR:
Eye Protection
Long Pants
Heavy Shoes
Cut from your right to yourleff.
Always release the throttle trigger and
allow the engine to returnto idle
speed when notcutting.
To stopengine:
• Release the throttletrigger.
Move the ON/OFF swi[c_ to the OFF
position.
TWIST AND EDGE
The Twist and Edge feature allows for
easy edging of sidewalks, patios,
driveways, etc.
1. Pull the tab toward the engine.
2. Twistthe tube to the edging posi-
tion; release tab.
TRIMMER LINE ADVANCE
The trimmer line will advance approxi-
mately 2 In. (5 cm) each time the bot-
tom of the trimmer head istapped on
the groundwith the engine runningat
full throttle.The most efficient line
length isthe maximum length allowed
by the line,miter.
Always keep the shield in place when
the tool isbeing operated.
To advance line:
• Operate the engine at fullthrottle.
Holdthe trimmerhead parallelto and
above the grassyarea.
• Tap the bottomof thetrimmerhead
lightlyonthe groundone time. Ap-
proximately21n. (5 cm) of linewillbe
advancedwitheaChtap.
Toadvanceline,tapbottomof trimmer
headon groundonetime.
Line limiter cutsline 1
properlength.
_IL WARNING: Always wear eye
protection. Never lean over the trim-
mer head. Rocks or debris can rico-
chet or be thrown into eyes and face
and cause blindness or other serious
injury.
Do not run the engine at a higher
speed than necessary. The cutting
line will cut efficiently when the engine
is run at less than full throttle. At lower
speeds, there is less engine noise and
vibration. The cutting line will last
longer and will be less likely to '_Neld"
onto the spool.
Always tap the trimmer head on a
grassy area. Tapping on surfaces such
as concrete or asphalt can cause ex-
cessive wear to the trimmer head.
If the line is worn down to 2 in. (5 cm) or
less, more than one tap will be required
to obtain the most efficient line length.
_,WARNING: Use only 0.080"
(2 mm) diameter line. Other sizes of
line will not advance properly and can
cause serious injury. Do not use other
materials such as wire, string, rope,
7
Loading ...
Loading ...
Loading ...