Loading ...
Loading ...
Loading ...
(134,1)
北米Model "A1490BE-A" EDITED: 2022/ 2/ 15
– Push-button ignition switch is
turned to the “ACC” position (mod-
els with “keyless access with push-
button start system”).
& Disarming the system
S02AF05
Perform either of the following procedures.
. Briefly press a button (for less than 2
seconds) on the access key fob/remote
transmitter.
. Carry the access key fob and perform
either of the following procedures (models
with “keyless access with push-button
start system”).
– Grip the front door handle.
– Press the rear gate opener button.
– Unlock using the PIN code access.
The flashing of the security indicator light
will then change slowly (once approxi-
mately every 3 seconds from twice ap-
proximately every 2 seconds), indicating
that the alarm system has been disarmed.
! Emergency disarming
S02AF0501
If you cannot disarm the system using the
access key fob/transmitter (i.e. the trans-
mitter is lost, broken or the transmitter
battery is too weak), you can disarm the
system without using the access key fob/
remote transmitter.
The system can be disarmed if you turn the
ignition switch from the “LOCK”/“OFF” to
the “ON” position with a registered key/
access key fob.
NOTE
For models with “keyless access with
push-button start system”, if the ac-
cess key fob battery is discharged,
perform the procedure described in
“Switching power status” �9-18. In
such a case, replace the battery im-
mediately. Refer to “Replacing battery
of access key fob” �11-46.
& Alarm system setting
S02AF11
To change the setting of your vehicle’s
alarm system for activation or deactiva-
tion, do the following.
1. Disarm the alarm system. Refer to
“Disarming the system” �2-26.
2. Sit in the driver’s seat and shut all
doors, rear gate and engine hood.
3. Turn the ignition switch to the “ON”
position.
4. Hold down “
” of the driver’s power
door locking switch, open the driver’s door
within the following 1 second, and wait 10
seconds without releasing the switch. The
setting will then be changed as follows.
. Type A combination meter
Setting
status
Combination
meter display
Horn
Activate ALon Once
Deactivate ALoF
Twice
. Type B combination meter
Setting
status
Combination
meter display
Horn
Activate AL ON Once
Deactivate AL OFF
Twice
NOTE
You may have the above setting change
done by your SUBARU dealer.
& If you have accidentally trig-
gered the alarm system
S02AF03
! To stop the alarm
S02AF0301
Do any of the following operations:
. Press any button on the access key fob/
remote transmitter.
. Turn the ignition switch to the “ON”
position (models without “keyless access
with push-button start system”).
. Turn the push-button ignition to the
“ACC” position (models with “keyless
access with push-button start system”).
Keys and doors/Alarm system
2-26
Loading ...
Loading ...
Loading ...