User Manual Shark WD201 WD200 Series HydroVac Cordless Pro XL 3-in-1 Vacuum, Mop & Self-Cleaning System

It is not recommended that you use third party cleaning solutions with the Hydrovac. The Hydrovac Multi Surface Cleaning Solution is specifically designed for this system to optimize cleaning performance. Third party cleaning solutions will lead to foaming, streaking and false triggering of the dirty water sensors

We do not recommend using bleach as it may damage the unit.

You can clean the brushroll by hand as an alternative to the self-clean cycle, and to remove debris or hair wrapped around the brushroll.

To access the brushroll, press the button on the top of the nozzle and lift off the brushroll cover.

Remove the brushroll by pulling up on the pull tab on the left side of the nozzle. Wipe away any debris stuck on the back wall. Wash thoroughly with warm water. Allow the brushroll to air-dry completely in a well-ventilated area for at least 24 hours.

Reinsert the brushroll by lining up the grooves on the end of the brushroll with the helix on the inner right side of the nozzle, then press down on the left side of the brushroll. When properly installed, the brushroll tab will be flush with the left side of the nozzle


To reinstall the brushroll cover, insert the tabs on the cover into the slots on the nozzle. Press down on the cover until it clicks into place.

The temperature can be between 40 degrees F and 95 degrees F. Normal tap water is good to use for cleaning. Please do not use boiling water as this may damage internal parts.