Loading ...
Loading ...
Loading ...
Mounting instructions
See image B7, B8, B9
The electrical connection should be made by a qualitied electrician, in
accordance with the relevant regulations (IEC, NEC, etc.)
The device has been connected to the electrical supply.
Cut the cable to the required length and connect it to the terminal
strip. Use the supplied cable boot to botain a good seal.
This appliance should be grounded.
See image B1, B2
Remove the screw with a philips-head screwdriver and open the top
cover. Remove the display plug and remove the top cover and put
beside.
See image B3
Install the supplied plumbing components as illustrated. The cold water
isolation valve (stop valve) should not be used to choke the flow through
the device.
Installation, See image B4, B5
1. Use two pieces of tape to fix the template on the wall where the
device is to be installed.
2. Drill two 5/16” holes through the template, as indicated.
3. Bear in mind where the water pipes will be installed later.
4. Install cold water inlet connecter to cold water supply (in the wall) to
the left, and hot water outlet connecter to hot water supply (in the wall) to
See image B6
1. Install the device with the supplied screws and anchors.
2. The cold water supply should be connected to the inlet on the right of
the device (blue=cold water).
3. The hot water pipe is installed to the left. Make sure the connections
are watertight! To prepare the connection to the water supply, Teflon tape
must be used for sealing the threads.
See image B10,B11
• Insert the display plug.
• Install the top of the housing.
• Insert the screw at the bottom.
14
Electric Tankless Water heater - Installation Maunal and User Guide
TM
Loading ...
Loading ...
Loading ...