Loading ...
Loading ...
Loading ...
© 2021 United States Stove Company
17
• Immediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
If you cannot reach your gas supplier, call the re
department.
C. Use only your hand to push in, or turn the gas
control knob. Never use tools. If the knob will
not push in or turn by hand, don’t try to repair
it. Call a qualied service technician. Force or
attempted repair may result in a re or explosion.
D. Do not use this appliance if any part of it has
been under water. Immediately call a qualied
service technician to inspect the appliance and
to replace any part of the control system and
any gas control that has been under water.
PILOT
OFF
Pilot
Hi/Lo Knob
Off/Pilot/On Knb
Burner Controls - Piezo
Ignitor, Control Knobs
Piezo
MILLIVOLT CONTROL LIGHTING
INSTRUCTIONS
1. STOP! Read All Labels.
2. Make sure the manual shutoff valve is fully open.
3. This heater is equipped with an ignition device
(piezo) which automatically lights the pilot. If
the pilot will not light using the piezo ignitor
refer to the manual lighting procedure.
4. Turn gas control knob clockwise to the “OFF”
position, set the thermostat to lowest setting
and turn the ON/OFF switch to the “OFF”
position.
5. Wait ve (5) ve minutes to clear out any gas.
Then smell for gas, including near the oor. If
you smell gas, STOP! Follow “B” in the safety
information label. If you don’t smell gas, go to
the next step.
6. From the “OFF” position, turn the gas control
knob counterclockwise to the “IGN” position.
Push in the control knob for (5) ve second.
7. With the control knob pushed in, push in and
release the pieso ignitor button to light the pilot.
8. Continue pushing the control knob in for a
further (60) sixty seconds to prevent the ame
detector from shutting off the gas while the
probe is warming up. Release the control knob.
9. Turn the gas control knob counterclockwise to
the “ON” position.
10. After the pilot has been lit for one minute, the
burners can be turned on. Turn the On/Off switch
to the “ON” position and adjust thermostat to
desired setting.
11. If the heater will not operate, follow the
instructions “To Turn Off Gas To Appliance” and
call your supplier.
12. Wait (30) thirty seconds before readjusting the
heater when the control knob has been turned
down to a lower setting.
Pilot
OFF
ON
Control Cover Plate for Millivolt
Hi/Lo Control
Ignitor/Pilot
Control
On/Off Switch
(Located on Side of
Stove)
TO TURN OFF GAS TO HEATER
1. Turn gas control knob clockwise to the “OFF”
position. Do not force.
2. Turn On/Off switch to the “OFF” position and/
or set the thermostat (if present) to the lowest
setting.
3. If applicable: Turn off all electric power to the
appliance.
OPERATION
Loading ...
Loading ...
Loading ...