Loading ...
Loading ...
Loading ...
4
31-1000561 Rev. 2
This instruction provides for the installation of a Statement or Minimalist
handle collection on a ½” flush inset custom panel.
HANDLE ASSEMBLY
• Insert Handle Mounting Fastener assembly E from the
nonappearance side of the panel
• Place the handle caps over the insert Handle Mounting
Fastener on the door. Take care to support the handle
so it doesn’t fall and scratch the appliance finish.
Make sure both handle caps are resting on the face of
the door.
• Lock one end of the handle into position by tightening
the countersunk screw D with the Allen wrench
provided.
• Keep supporting the handle as you lock the other
end of the handle into position by tightening the
countersunk screw D.
• Finally tighten the set screw in the handle caps using
the Allen wrench provided in the handle kit. DO NOT
over tighten the set screw using a power tool.
NOTE: Set screw location in end cap will vary by model.
When installing horizontal handles, position the handle
so that the set screws are facing downward.
D
Allen wrench
provided in
the kit
Insert Assembly E
Allen Key provided
with handle kit
1/4" backer panel
and 0.100" spacer
1/2" Wooden door panel
Handle Mounting Fastener
Insert Assembly
-
E
Installation Instructions
Loading ...
Loading ...
Loading ...