Loading ...
Loading ...
Loading ...
- 15 -
Revision 02/2022
Copyright © 2022, Fast ČR, a.s.
1. Disconnect the power plug from the power socket.
2. Remove the plug of the drain outlet A16. Connect the drain hose B7.
If the length of the drain hose B7 is insufficient, then it is necessary
to purchase alonger hose of the same type. Never extend the length
of the drain hose B7 using extensions.
3. Connect the end of the drain hose B7 to the waste water drain.
4. Insert the power plug into apower socket and turn on the mobile air
conditioner.
Note:
The drain hose B7 should be installed at the same height
or lower than the top drain outlet A16. Otherwise, the
condensate will not be properly drained from the water
tank.
Putting into operation again
• Check that the power cord and plug are not damaged and that the
air filters are clean. Insert anew set of batteries into the remote
control. Proceed according to the instructions in section „Inserting
and replacing batteries“. Install the mobile air conditioner according to
the instructions contained in the preceding part of this user‘smanual
„Installation“.
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TROUBLESHOOTING
• Before contacting an authorised service centre, please check the
appliance according to the following instructions:
Problem Cause Solution
The mobile air
conditioner does not
turn on when the
ON/OFF button is
pressed.
Error message P1. The condensate tank is
full. Turn off the mobile
air conditioner and drain
the condensate from the
condensate tank according
to the instructions in the
section "Condensate drain
outlet" in the preceding part
of this user'smanual.
In the cooling mode: the
temperature in the room
is lower than the set
temperature.
Adjust the set temperature.
The mobile air
conditioner does not
cool sufficiently.
The air filter is clogged
with dust and animal fur.
Turn off the mobile air
conditioner and clean out
the filter according to the
instructions in chapter
"Maintenance and cleaning".
The flexible air exhaust
hose is not connected or
it is clogged.
Turn off the mobile air
conditioner and check
the hose connection, or if
necessary, remove any
material inside the hose.
There is an insufficient
amount of refrigerant
gas in the mobile air
conditioner.
Contact an authorised
service centre.
You set atemperature
that is too high.
Lower the set temperature.
Windows or doors are
open.
Close any windows or doors.
The room is too large. Check recommended
room area.
Aheat source is turned
on in the room.
Turn off the heat source.
The mobile air
conditioner is too
noisy and vibrates
too much.
The mobile air
conditioner is located on
an uneven surface.
Move the mobile air
conditioner to an even and
level surface.
The air filter is clogged
with dust and animal fur.
Turn off the mobile air
conditioner and clean out
the filter according to the
instructions in chapter
"Maintenance and cleaning".
The mobile air
conditioner is
emitting gurgling
sounds.
The noise is caused by
the movement of the
refrigerant inside the
mobile air conditioner.
This is normal.
Note:
In the event that one of the aforementioned faults occurs,
turn off the mobile air conditioner and check for the cause
of the fault. Turn it on again, and if the fault reoccurs, turn it
off, disconnect the power cord from the power socket and
contact the manufacturer, an authorised service centre
or aperson with relevant qualifications and have the unit
repaired.
Error messages
Error messages may appear on the display C13 during operation:
Error
message
Meaning Solution
E1
Heat sensor error
Contact an authorised service
centre.
E2
Evaporation temperature
sensor error
Contact an authorised service
centre.
E3
Condensate temperature
sensor error
Contact an authorised service
centre.
E4
Display panel error
Contact an authorised service
centre.
EC
Refrigerant leak
Contact an authorised service
centre.
P1
The condensate tank
is full.
Connect the drain hose – proceed
according to the instructions in
section "Condensate drain outlet".
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
TECHNICAL SPECIFICATIONS
Power supply 220 – 240 V~ / 50 Hz
Cooling power output 12.000 Btu/h
Input power / cooling input power 1,450 W / 1,350 W
El. current draw / Cooling draw 8.0 A/ 5.9 A
EER cooling factor 2.6
Dehumidification capacity 84 l / day
Capacity of the built-in condensate tank 1 l
Refrigerant type and weight R290 / 210 g / GWP 3
Air flow volume
420 / 370 / 355 m3/h
(Hi / Mi / Lo)
Noise level 63 dB (A)
Maximum permitted value of excess
operating pressure: Suction/exhaust part of
the cooling circuit
2.6 / 1.0 MPa
Dimensions of the mobile air conditioner
(w× d × h)
467 × 397 × 765 mm
Weight 32.5 kg (net)
Operating temperature (cooling) 17-35°C
Recommended room area (Central Europe 42 - 47 m
2
Recommended room size (Central Europe) 109 - 122 m
3
*
Loading ...
Loading ...