Craftsman 917276181 tractor

User Manual - Page 24

For 917276181.

PDF File Manual, 64 pages, Download pdf file

Loading ...
Loading ...
Loading ...
° If front tip of blade is not 1/8" to 1/2"
lower than the rear tip, go to the front of
tractor.
With an 11/t6" or adjustable wrench,
loosen jam nut A several turns to clear
adjustment nut B.
With a 3/4" or adjustable wrench, turn
front link adjustment nut (B) clockwise
(tighten) to raise the front of mower, or,
counterclockwise (loosen) to lower the
front mower.
NOTE: Each full turn of the adjustment
nut will change mower height about 1/8'L
° Recheck measurements, adjust if nec-
essary until front tip of blade is t/8" to
1/2" lower than the rear tipo
Hold adjustment nut in position with
wrench and tighten jam nut securely
against adjustment nut,
MOWER DRIVE BELT INSTALLATION
1. Install belt around all mandrel pulleys
(R) and around idler pulleys (S) as
shown,
2. Install belt onto electric clutch pulley
(M).
IMPORTANT: Check belt for proper rout-
ing in all mower pulley grooves,
3. Raise attachment lift lever to highest
position.
Tighten adjust nut
B to raise mower
Loosen adjust nut
B to lower mower
Loosen jam nut A first
TO REPLACE MOWER DRIVE BELT
MOWER DRIVE BELT REMOVAL
1, Park tractor on a level surface° Engage
parking brake,
2. Lower attachment lift lever to its lowest
position.
3. Remove any dirt or grass clippings
which may have accumulated around
mandrels and entire upper deck sur-
face.
4. Remove belt from electric clutch pulley
(M), both mandrel pulleys (R) and all
idler pulleys (S).
TO REPLACE MOTION DRIVE BELT
Park the tractor on level surface_ Engage
parking brake. For assistance, there is a
belt installation guide decal on bottom side
of left footrest.
BELT REMOVAL -
1. Remove mower (See 'q'O REMOVE
MOWER" in this section of manual).
NOTE: Observe entire motion drive belt
and position of al! belt guides and keepers,
2. Remove belt from stationary idler (A)
and clutching idler (B).
3, Remove belt from centerspan idler (C).
6. Pull belt slack toward rear of tractor.
Carefully remove belt upwards from
transmission input pulley and over
cooling fan blades (D).
4. Remove belt downward from engine
pulley (E).
5. Slide belt toward rear of tractor, off the
steering plate (F) and remove from
tractor,
BELT INSTALLATION -
1, Install new belt from tractor rear to
front, over the steering plate (F) and
above clutch brake pedal shaft (G).
2, Pull belt toward front of tractor and rol!
belt onto engine pulley (E),
24
Loading ...
Loading ...
Loading ...