Loading ...
Loading ...
Loading ...
16
CARE AND MAINTENANCEUSING YOUR APPLIANCE
Changing the light bulb - Manual models
WARNING!
Before changing any light bulb, switch the power off at
the power point and remove the power cord from the
power point.
•Refrigeratorlight
1. Switch off the power at the power point and remove
the refrigerator’s power cord from the power point.
2. Remove shelves.
3. Using a flat blade screwdriver, push clips down while
pulling the lens forward. Carefully unclip the light cover.
You do this by pulling the upper part of the cover
towards the front of the cabinet.
4. Unscrew the light bulb and replace it with a bulb that
is the same as the original. If, when you remove the
light bulb the small rubber “O” ring comes out with
the bulb, fit the “O” ring over the new bulb and screw
bulb into the socket (see diagram below).
WARNING!
Neverinsertyourngerintothelightbulbsocketto
check for the presence of the “O” ring.
5. Replace the light cover by hooking the light cover lugs
into the bottom of the housing and pressing the upper
part of the cover until it clips in.
6. Replace shelves.
7. Wait 5 minutes to ensure pressures in the refrigeration
system are equalized. Then reconnect and turn the
refrigerator on at the power point.
TIPS & INFORMATION!
Ensure the ‘O’ ring is in place before replacing the bulb.
Light bulb “O” ring Light socket
LEDlighting-Electronicmodels
Your refrigerator is fitted with long life LED lighting. In the
unlikely event the LED lights should fail, then the LED lights
should be serviced by the manufacturer, it’s service agent
or similarly qualified technician. Refer to the warranty page
for contact details.
When the door is left open for 15 minutes, the LED light will
dim to 50% brightness to conserve energy and prolong
the life of the LED. If the door is left open for a further 15
minutes, the light will automatically turn off. Close and
reopen the door again to turn the light back on.
Twist ice & serve (where fitted)
Top mount, bottom mount and single door all vertical
freezer models have a twist ice & serve ice cube
tray assembly.
To use, remove the tray, fill with water and place back in
the freezer. Once ice has formed (approximately 3 hours)
simply twist the knob at the front clockwise until the ice
drops into the bin below.
A larger bin is provided in some bottom mount models
along with an ice scoop.
Ice station
Mounting the twist & serve ice to the other side
of the freezer (top mount and built-in freezer
models only)
1. Remove the ice bin and ice cube tray. If the ice tray
assembly is frozen to the carriage, simply squeeze the
tray and shelf together to break the ice.
2. Before you remove the ice carriage, remember to
disengage it from the glass shelf (as shown), as it may
result in damage to the assembly.
3. Remove the centre runner by disengaging it at the
front of the shelf, and removing it from the rear.
4. Refit the runner in to the rear of the shelf on the right
hand side and then engage the front (as shown).
insert into the
slot at the rear
of the shelf
then engage
into the front
of the shelf
5. Fit the carriage by sliding it into the runners until the
front of the carriage engages with the shelf.
6. Refit the ice tray and ice bin.
Loading ...
Loading ...
Loading ...