Loading ...
Loading ...
Loading ...
17
RQT9961
17
ENGLISH
Occasionally, Panasonic may release updated
software for this unit that may add or improve the
way a feature operates. These updates are
available free of charge.
For more details, refer to the following website.
http://panasonic.jp/support/global/cs/
(This site is in English only.)
∫ Checking the software version
The version of the installed software is displayed.
Press [SETUP] repeatedly to select “SW VER.” and
then press [OK].
≥ Press [OK] to exit.
When other Panasonic equipment responds to the
supplied remote control, change the remote control
code.
Preparation
Press [AUX] to select “AUX 1” or “AUX 2”.
∫ To set the code to “REMOTE 2”
1 While pressing and holding [USB] on the unit,
press and hold [AUX] on the remote control
until the unit’s display shows “REMOTE 2”.
2 Press and hold [OK] and [USB] on the remote
control for at least 4 seconds.
∫ To set the code to “REMOTE 1”
1 While pressing and holding [USB] on the unit,
press and hold [USB] on the remote control
until the unit’s display shows “REMOTE 1”.
2 Press and hold [OK] and [ ] on the remote
control for at least 4 seconds.
Troubleshooting
Before requesting service, make the following
checks. If you are uncertain about some of the
check points, or if the solutions indicated in the
following guide does not resolve the issue, then
consult your dealer for instructions.
Humming heard during playback.
≥ If an AC mains lead or fluorescent lights are near
the cords, then keep other appliances and cords
away from the cables.
The unit does not work.
≥ One of the unit’s safety devices may have been
activated.
Reset the unit as follows:
1 Press [Í/I] on the unit to switch the unit to
standby.
≥ If the unit does not switch to standby, press
[Í/I] on the unit for approximately
10 seconds. The unit is forcibly switched to
standby. Alternatively, disconnect the AC
mains lead, wait for at least 3 minutes, then
reconnect it.
2 Press [Í/I] on the unit to switch it on. If the
unit still cannot be operated, consult the
dealer.
The display panel lights up and changes
continuously in standby mode.
≥ Press and hold [∫] on the unit to select “DEMO
OFF”.
Software update
Remote control code
To return all settings to the factory defaults
When the following situations occur, reset the
memory:
≥ There is no response when buttons are pressed.
≥ You want to clear and reset the memory contents.
1 Disconnect the AC mains lead. (Wait for at least
3 minutes before proceeding to step 2.)
2 While pressing and holding down [Í/I] on the
unit, reconnect the AC mains lead.
≥ Keep holding down [Í/I] until “--------” appears on the
display.
3 Release [Í/I].
≥ All the settings are returned to the factory defaults. You will
need to reset the memory items.
General
SC-CMAX5_GS~RQT9961-G.book 17 ページ ２０１４年８月２２日 金曜日 午後７時８分
Loading ...
Loading ...
Loading ...