Loading ...
Loading ...
Loading ...
Operation(Continued)
t_
,m
WARNING
DONOTattempt any maintenance,adjustments or service
with engine and blade running. STOPengine and blade.
Disconnectspark plug wire and secure away from spark
plug. Engineand components are HOT.Avoid serious
burns, allow sufficient time for all components to cool.
Installingthe DischargeDeflector
1. Removethe recycling cover. Referto the Section entitled
"Recycling Operation".
2. Install the deflector (A, Figure11) to the deck in place
of the recycling cover,making sure that:
• Thefront hole (B) on the outside front of the
deflector fits over the stud wherethe front of the
recycling cover was originally secured
• Theslot (C) on top of the deflector slips underthe
restraining nut on top of the deck (under the right
front corner of the engine)
• Theslot (D) on the inside rear of the deflector slips
onto the stud behind the rear of the discharge
opening, wherethe rear of the recycling cover was
originally secured.
3. Install the internal/externaltooth lock washersand knob
nuts onto the studs andtighten securely.
Figure 11: Installing the discharge deflector
Installingthe GrassBagAdapter
(Optional Accessoryon Some Models)
1. Removethe recycling cover. Referto the Section entitled
"Recycling Operation".
2. Install the adapter(A, Figure 12) to the deck in placeof
the recycling cover, making surethat:
• Thefront hole (B) on the outside front of the
adapterfits over the stud where thefront of the
recycling cover was originally secured
• Theslot (C) on top of the adapterslips under the
restraining nut on top of the deck (under the right
front corner of the engine)
• Theslot (D) on the rear of the adapterslips onto
the stud behind the rear of the discharge opening,
wherethe rear of the recycling cover was
originally secured.
3. Install the internal/externaltooth lock washersand knob
nuts onto the studs and tighten securely.
4. Route the recoil rope around the outside of the rope
guide pulley (E).
Note:The recoil rope may needto be slackened. Referto the
section entitled "HandleAssembly".
.
Figure 12.Installing the grass bag adapter
(Kawasakienginesonly) Attachthe grass bag adapter
standoff (A, Figure13) betweenthe rope guide pulley
and the engine recoil:
• Removethe right rear bolt (B) from the
engine recoil
• Removethe torx screwand nut securing the rope
guide pulley (C)to the bracket on the bagadapter
• Laythe standoff betweenthe bolt holes in the
engine recoil and the bag adapterpulley bracket.
(Position the standoff so that the bent end (D) is
toward the engine recoil cover.)
8 www.snapper.com
Loading ...
Loading ...
Loading ...