Loading ...
Loading ...
Loading ...
Component Replacement
Although Endurance provides the highest quality of
materials and workmanship in its products, the fact
remains that component parts eventually wear out over
time and with use.
Carefully read the instructions below when replacing wear parts on your ESB250.2 Spin Bike.
HANDLEBAR REPLACEMENT
To replace the handlebar:
Loosen Handle (39) while holding onto Handlebar
(D). See Diagram 1.
Remove Handle (39), Washer (66), then remove
Handlebar (D).
Replace the old Handlebar with the new Handlebar
(D) and place it on Handlebar Post (B) as shown.
See Diagram 2
Reinsert Washer (66) and Handle (39).
Tighten the assembly and carefully check for no
loose components.
BRAKE PAD REPLACEMENT
To replace the brake pad:
Loosen Socket Head Bolts (61).
See Diagram 3.
Remove Socket Head Bolts (61) and Washers (67).
See Diagram 4.
Secure Acorn Cap Nuts (45) with a wrench then re-
move Phillips Bolts (55) and Washers (69).
See Diagram 5.
Separate Brake Cushion (12) and Brake Pad (11)
from Brake Holder (32).
Clean Brake Holder (32).
Spread glue on Brake Holder (32) then stick the
new Brake Cushion (12) on Brake Holder (32).
Place Brake Pad (11) on top of Brake Cushion (12)
then secure the assembly using Phillip Bolts (55),
Washers (69) and Acorn Cap Nuts (45).
Install the new brake assembly onto the main frame
using Socket Head Bolts (61) and Washers (67).
Diagram 1
Diagram 2
Diagram 3
olumn Bolt M5*12L 2PCS 61
Diagram 4
Diagram 5
A.
B.
C.
D.
E.
A.
B.
C.
D.
E.
F.
G.
H.
Loading ...
Loading ...
Loading ...