Loading ...
Loading ...
Loading ...
Threading the Machine
• Threading the machine
* Raise the thread take-up lever to its highest position by
turning the handwheel counterclockwise.
* Raise the presser foot lifter.
* Place a spool on the spool pin, with the thread coming
off as shown.
[] Draw the end of the thread around the upper thread guide.
[] While holding the thread near the spool, draw the end of
the thread down around the check spring holder.
[] Firmly draw the thread up from right to left over the
take-up lever, and down into the take-up lever eye.
[] Slide the thread behind the needle bar thread guide on
the left.
[] Thread the needle from front to back, or use a needle
threader.
• Needle threader
_i_ Knob
_2_Hook
_3_Guide
_4_Thread end
[1!]Raise the needle to its highest position. Push down the
needle threader knob _i_ as far as it will go.
The hook comes out through the needle eye from
behind.
[2] Paying close attention to the needle point, draw the
thread around the guide _3_and under the hook _2_.
[13]Release the knob slowly while holding the thread end _4_
with your hand. A loop of the thread is pulled up through
the needle eye.
NOTE:
The needle threader can be used with a # 11 to # 16
needle, or a # 11 Blue needle.
Thread size 50 to 100 is recommended.
f
[]
[]
_\\\\
\
I
[]
t
\
\
\
i
1
J
_ J
26
Loading ...
Loading ...
Loading ...