Loading ...
Loading ...
Loading ...
7
INSTALLATION INSTRUCTIONS
Before Using Your Refrigerator
• Remove the exterior and interior packing.
• Before connecting the unit to the power source, let it stand for approximately 2 hours. This will
reduce the possibility of a malfunction in the cooling system from handling during
transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
Installing your Refrigerator
MC2
• This appliance is designed to be free-standing only, and should not be recessed or built-in.
• When installing the unit, allow 5 inches of space at the back, sides and top of the unit, which
will allow the proper air circulation to cool the compressor and condenser.
• Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extremely cold ambient temperatures may also affect the unit's
performance.
• Avoid locating the unit in moist areas.
• Plug the unit into an exclusive, properly installed and grounded wall outlet. Do not under
any circumstances cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician or authorized service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down for 2 to 3 hours
before placing food inside.
MC6BI
• This appliance is designed to be free-standing or built-in.
• Your refrigerator needs at least ¼” (6.35mm) of air space at the top and on the sides, and 2”
at the rear to allow for proper air ventilation. Be sure the airflow under the appliance is not
blocked. If the refrigerator is installed next to a fixed wall, provide at least 2 ½” (6.35cm) of
room on the hinge side to allow for the door to swing open.
• Avoid direct sunlight and heat. Light will discolor the outer finish. In addition, when placed near
a heat source, such as a stove or direct sunlight, the refrigerator will consume more electricity.
Similarly, avoid installing the relatively cold locations: do not install in a place where the
temperature will fall below 55°F (13°C).
• Avoid moisture. If placed near a sink or water faucet, the evaporator will frost faster because
of the higher humidity.
CP34WMC/CP34BSSMC
• This appliance is designed for free-standing use.
• Your refrigerator-freezer needs at least 2” (50.8mm) of air space at the top and at the rear, and
¾” of air space on the sides to allow for proper air ventilation. Be sure the airflow under the
appliance is not blocked.
• Avoid direct sunlight and heat. Similarly, avoid installing in cold conditions. Do not install in a
place where the temperature will fall below 55°F (13°C).
Loading ...
Loading ...
Loading ...