Loading ...
Loading ...
Loading ...
11
Reversing the Door Swing (CP34WMC/CP34BSSMC)
The doors of the CP34WMC refrigerator-freezer can be hinged on either side so the door swing can be
suited to the location of the installation.
1. Remove the upper hinge cap.
2. Remove the upper hinge screws. The top hinge and the freezer door can now be removed. Be sure
to place the freezer door on a soft surface to prevent any damage.
3. Remove the middle hinge screws. The middle hinge and the refrigerator door can now be removed.
4. Remove the cover for the middle hinge holes and re-attach the hinge symmetrically to the holes on
the other side, making sure the plastic hinge pin is facing upward to support the door when
reversed.
5. Tilt the refrigerator back or lay it on its back for steps 6, 7 and 8. Use a pad or blanket to protect the
floor and to avoid scratching the painted finish.
6. Remove the lower hinge screws.
7. Attach the bottom hinge symmetrically to the other side of the cabinet, making sure the hinge pin is
facing upward to support the door when reversed.
NOTE: There may be screws already in the opposite side of the cabinet for use. If not, use the screws
removed in Step 6.
8. Remove the upper hinge plastic covers and insert them in the holes from which the screws were
removed in Step 2.
9. Take off the hinge hole caps from both the freezer and refrigerator doors using a screwdriver and
insert them in the hinge holes on the opposite side.
10. Rotate the middle hinge 180°. Attach it to the refrigerator door and secure it with screws. (Do not
tighten screws completely.)
11. Attach the upper hinge to the freezer door. Attach the freezer door to the middle hinge and use the
screws to attach the upper hinge. (Do not tighten screws completely.)
12. The direction in which the doors open has now been changed.
Freezer Door Alignment (CP34WMC/CP34BSSMC)
1. Remove the top hinge cover.
2. Loosen the top hinge screws using a Phillips head
screwdriver.
3. Adjust the door or put a spacer in between, and then
tighten the screws.
4. Replace the top hinge cover.
Loading ...
Loading ...
Loading ...