Loading ...
Loading ...
Loading ...
14
Operations
Machine Set Up & Installation
Uncrating Machine
Be sure and check packing carton for any damage.
Immediately report any damage to carrier. Check the
contents of package to ensure that the following items
are included:
• Machine
• 4-6V Batteries
• Squeegee assembly
• 2-Pad drivers
1. Uncrate the wooden box, place the top board on
the edge of pallet, lie in the front of the machine, as
below shown.
Do not operate machine unless you have read &
understood this manual.
2. Install batteries.
3. Turn on the Main power key switch, make sure the
Squeegee assembly and the Scrub head assembly
are off the floor.
4. Sit in the Operator seat, hold the steering wheel,
press the accelerator pedal and drive the machine
slowly down from the slope.
Installing Batteries
Batteries emit hydrogen gas. Explosion or fire can
result from hydrogen gas. Keep sparks and open
flames away! Keep battery compartment open
when charging.
Recommended battery spec:
4-6V, 260AH@20HR deep cycle batteries.
Max. battery dimensions
300mm (L) X 180mm (W) X 290mm (H)
1. Turn the Main power key switch off.
2. Remove the Operator seat & the Battery box.
3. Carefully place the batteries into the compartment
as shown in the figure below. Place the battery
brace at the rear of the batteries.
NOTE: Do not drop the batteries into the
compartment!
4. Connect battery cables to posts in numbered order
as shown in drawing below.
NOTE: RED to POSITIVE and BLACK to
NEGATIVE.
5. Reinstall the Operator seat and the Battery box.
Machine Set Up
Installing Brushes Or Pads
1. Turn off the 1-Step switch and raise the Scrub
head assembly off of the floor, then stop machine
on the level surface, remove the key and ensure
the machine is turned off.
2. If using the pad driver, first attach the appropriate
pad to the pad driver surface.
8.645-040.0 Operator Manual KIRA B100 R
Loading ...
Loading ...
Loading ...