Loading ...
Loading ...
Loading ...
Set Water Hardness Number
1. Press the _ PROGRAM button once again to display a flashing 25 and the word"HARDNESS".
7F
HARDNESS
2. Press the _ Up or _ Down buttons to set your water hardness number.
NOTE: Be sure to enter the grains per gallon (gpg) hardness of your water supply on page 5, for
future refcrence. If your water supply contains iron, compensate for it by adding to the
water hardness number. For example, assume your water is 20 gpg hard and contains 2
ppm iron. Add 5 to the hardness number for each 1 ppm of iron. In this example, you
would use 30 fl)r your hardness number.
20 gpg hardness
2 ppm iron x 5 = 10 +10
(times) 30 HARDNESS NUMBER
Set Recharge (Regeneration) Time
1. Press the O PROGRAM button once again to display a flashing 2:00AM and the words
"RECHARGE TIME". This is a good time fk)r the recharge to start in most households because
water is not in use.
--I,1--117 AM
C'UU
RECHARGE TIME
2.
If you want to change the recharge start time, press the _ Up or _ Down buttons until the
desired starting time shows.
Press the (_ PROGRAM button once again to return to normal operating display.
Start a Recharge
PresstheORE(HARGEbuttonalxlholdforthreesccondsulltfltheword Recharge beglns to flash
in the timer display, starting a recharge. This recharge draws the sanitizing bleach into and through the
water softener. Any air remaining in the water softener is purged to the drain.
If you have questions about installation, electronic programming, operating and routine maintenance...
call 1-866-986-3223, Monday - Friday, 8 am to 9 pm, EST.
18
Loading ...
Loading ...
Loading ...