Loading ...
Loading ...
Loading ...
Care & Cleaning
Cleaning surface burners
To avoid possible burns DO NOT attempt
any of the cleaning instructions provided before turning
OFF aii of the surface burners and allow them to cool.
For proper gas flow it may be necessary to clean the
burner ports. Before cleaning be sure the gas burners are
turned off. First use a clean DAMP cloth to soak up any
spills. Remove any food from the burner ports using a
small nonabrasive brush like a toothbrush and afterwards
wipe up using a damp cloth. For stubborn soils located in
the burner ports, use a small gauge wire or needle to
dean.
Any spill on or around the electrode must be carefully
cleaned. Take care not to hit the electrode with any thing
hard or it could be damaged.
For fuji access to the surface burners, follow the
instructions for raising and lowering the cooktop.
Removing and replacing surface burners
Any additions, changes or conversions
required in order for this appliance to satisfactorily meet
the application needs must be made by an authorized
qualified Agency.
To remove gas burners:
1. Raise the cooktop.
2. Remove shipping screws using a Phillips Head
screwdriver. See Fig. 1 for screw locations.
3. Tilt the burner at the end closest to the support bar
until the Iocator tab is released (front burners tilt right,
rear burners tilt left). Move the burner toward the
back of the range. This will separate it from the gas
valve at the front of the range.
To replace gas burners:
1. Slide the burner tube over the gas valve at the front of
the range (front burners fit over the right valve, rear
burners fit over the left valve on each side of the
range).
2. Tilt burner so that the locating tab will slide into slot on
the support bar. Maize sure burners are properly
seated on support bar and are level (See Fig. 1).
3. Replace shipping screws.
4. Lower the cooktop.
rear burners
shipping_
locating
tab
locating
tab
-- front burners
burner
support bar
Fig. 1
gas
valves
Replacing oven light (some models)
Be sure the range is unplugged and all
parts are COOL before replacing oven light. Wear a
leather-faced glove for protection against possible broken
glass.
To replace oven light bulb:
1. Turn electrical power off
at the main source or
unplug the range.
2. Replace bulb with a new
40 watt appliance bulb
(See Fig. 2).
3. Turn power back on
again at the main source
(or plug the appliance
back in).
4. The clock will need to be
reset with the time of day.
To reset, see the Oven
Controls section in this Use
& Care Guide.
oven
Fig. 2
17
Loading ...
Loading ...
Loading ...