Loading ...
Loading ...
Loading ...
3 Using for the first time
3.1 Note
The appliance can only be operated after standing in the normal op-
erating position for about 2 hours.
The appliance must be installed and connected to the electricity supply in ac-
cordance with the separate installation instructions. Have a qualified fitter/elec-
trician carry out the necessary work.
3.2 Function description
The function test must not be confused with the definitive initial use.
See installation instructions: TL WP J12001 or TS WP/TSL WP
J12002.
When the appliance is connected to the power supply for the first time, it is
possible to select a function test. The purpose of the function test is to check
the installation. It takes about 3 minutes. The function test can be selected im-
mediately after installation. The heat pump is not started during the function
test. Before the definitive initial start-up of the appliance, it must stand in the
normal operating position for around 2 hours, otherwise the heat pump could
become damaged.
The function test cannot be aborted by interrupting the power supply.
Once the function test has been run or aborted, it can no longer be
selected and the appliance enters the normal selection mode.
13
Loading ...
Loading ...
Loading ...