Loading ...
Loading ...
Loading ...
page 7
10. Light Kit Assembly.
Remove 1 screw from motor plate on underside of
motor housing and partially loosen the other 2
screws. Align slotted holes in fitter plate with
loosened screws in motor plate, allowing molex
plugs from motor housing to come through hole in
middle of fitter plate. Twist fitter plate to lock.
Re-insert screw that was previously removed and
securely tighten all 3 screws with a Phillips
screwdriver. [Refer to diagram 1.]
Remove 1 screw from fitter plate and partially loosen
the other 2 screws.
Connect WHITE wire from LED light kit to WHITE
wire from motor housing. Connect BLACK wire from
LED light kit to BLUE (or BLACK) wire from motor
housing. Be sure that molex connections snap
together completely. Align slotted holes in
LED light
kit
with loosened screws in fitter plate. Twist LED
light kit to lock. Re-insert screw that was previously
removed and tighten all 3 screws securely. [Refer to
diagram 2.]
Locate slots on glass shade and align with nodules
on inside of fitter plate. Gently push up on glass
shade and turn to the RIGHT (clockwise) until it
slides completely into place. [Refer to diagram 3.]
Note: Pull down VERY GENTLY on glass shade to make
sure that glass shade is secure.
9. Blade Assembly.
WARNING: To reduce the risk of serious bodily injury,
DO NOT use power tools to assemble the blades. If
overtightened, blades may crack and break.
Time Saver: Washers for blade screws can be set on
each blade screw prior to installing blades.
Locate 15 blade attachment screws and washers in
one of the hardware packs. Hold blade arm up to
blade and align holes. Insert 3 blade attachment
screws (along with washers) with fingers first and then
tighten screws securely with a Phillips screwdriver.
Repeat for the remaining blades.
Remove blade arm screws and lock washers from
underside of motor. If plastic motor locks are installed
with blade arm screws, discard plastic motor locks.
Align blade arm holes with motor screw holes and
attach blade arm with lock washers and blade arm
screws. Before securing screws permanently, repeat
with remaining blade arms. Securely tighten all screws.
Note: Tighten blade arm screws twice a year.
motor housing
motor plate
diagram 3
molex connections
fitter plate
LED light kit
fitter plate
glass shade
slot
nodule
diagram 1
diagram 2
motor housing
blade arm
blade
blade attachment
screws and washers
lock washers
blade arm screws
plastic
motor
lock
fitter plate
molex connections
motor housing
Loading ...
Loading ...
Loading ...