Loading ...
Loading ...
Loading ...
page 6
7. Wiring.
WARNING: Turn off circuit breakers to current
fixture from breaker panel and be sure switch is
turned to the OFF position.
CAUTION: Be sure outlet box is properly
grounded and that a ground wire (GREEN or
Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with
electrical wiring or if the house/building wires are
different colors than those referred to in the
diagram to the right, please use a qualified
electrician.
Wire the receiver with wire connectors
provided as shown in diagram at right.
Tip: While you are wiring, keep in mind that
wires must not obstruct receiver from sliding
into hanging bracket.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
Insert receiver into hanging bracket (flat side
up) and gently push taped wire connectors into
outlet box. Allow antenna from remote control
receiver to hang out of the hanging bracket.
8. Canopy Assembly.
Temporarily raise canopy to hanging bracket to
determine which 2 screws in hanging bracket
align with slotted holes in canopy, and then lower
canopy and partially loosen these 2 screws.
Remove the other 2 screws/lock washers and set
aside.
Now, lift canopy to hanging bracket again,
aligning slotted holes in the canopy with
loosened screws in hanging bracket. Twist canopy
to lock. Re-insert the other 2 screws/washers and
secure all screws with a Phillips screwdriver.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
white supply wire
black supply wire
black
black
white
blue
white
from receiver
black
AC IN L
AC IN N
white
white
ground (green
or bare)
from fan
from receiver
antenna
from ceiling
receiver
ground
(green or bare)
black
screw
antenna
hanging bracket
canopy
blue
Loading ...
Loading ...
Loading ...