Loading ...
Loading ...
Loading ...
Your new tractor has been assembled at the factory with exception of those parts left
unassembled for shipping purposes. To ensure safe and proper operation of your tractor
all parts and hardware you assemble must be tightened securely. Use the correct tools
as necessary to insure proper tightness• Review tee video cassette before you begin.
TOOLS REQUIRED FOR
ASSEMBLY
Asocket wrench set will make assembly
easier. Standard wrench sizes you need
are listedbelow.
(1) 9/16" wrench (2) 1/2" wrench
(1) Phillips Screw- (1) Pliers
driver (1) Tire pressure
(1) Utility knife gauge
(1) 3/4" Socket with drive ratchet
When right or left hand is mentioned in
this manual, itmeans, from your pointof
view, when you are in the operating posi-
tion (seated behind the steering wheel).
TO REMOVE TRACTOR FROM
CARTON
UNPACK CARTON
• Remove all accessible loose parts and
parts boxes from shipping carton (See
page 6).
• Cut, from top to bottom, along lines on
all four comers ofshipping carton, and
• lay panels flat.
• Check for any additional loose parts or
boxes and remove•
BEFORE ROLLING TRACTOR OFF
SKID
ATTACH STEERING WHEEL
ASSEMBLE EXTENSION SHAFT AND
BOOT
• Slide extension shaft onto lower steer-
ing shaft. Align mounting holes in exten-
sion and lower shafts and install 5/16
hex bolt and Iocknut. "tighten securely.
IMPORTANT: Tighten bolt and nut secure-
ly to 18-22 ft. Ibs. torque.
• Place tabs of steering boot over tab
slots in dash and push down to secure.
INSTALL STEERING WHEEL
• Position front wheels of the tractor so
they are pointing straight forward.
• Slide steedng wheel adapter onto steer-
ing shaft extension.
• Position steeringwheel so cross bars
are horizontal (left to right)and slide
inside boot and onto adapter•
• Assemblelargeflat washer, 3/8 lock
washer,3/8 hex bolt and tightensecurely.
• Snap steering wheel insert intocenter
of steering wheel.
• Remove protective materials from trac-
tor hood and grill.
IMPORTANT: Check for and remove any
staples in skid that may puncture tires
where tractor is to rolloff skid•
3/8 HsxBolt
1--- ,o k
__sher
Steedng f/_-_._ _"_ Large Flat
Wheel _9 Washer
Steering Boot
Tabs
TO ROLL TRACTOR OFF SKID (See
Operation section for location and
function of controls)
• Press liftlever plunger and raise attach-
ment liftlever to its highest position.
• Release parking brake by depressing
clutch/brake pedal.
• Place gearshift lever in neutral (N) posi-
tion.
• Roll tractor forward off skid.
• Remove banding holding discharge
guard up against tractor.
Loading ...
Loading ...
Loading ...