Loading ...
Loading ...
Loading ...
page 6
6. Wiring. (cont.)
[PLEASE NOTE: Wall and/or handheld remote
control must be used for fan to operate. If you do
not wish to use the wall control, please proceed to
Section 7 to continue with fan installation.]
To install wall control, remove existing wall switch.
Wire one of the wall controls with wire connectors
provided as shown in diagram at right.
*Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Install one 12-volt battery (included) in wall control.
IMPORTANT: Wall control will not function unless
battery is installed.
The bulbs provided with this fan are not
compatible with dimmer controls; therefore, the
dimmer switch (labeled DIM and ON) has been
pre-set to the "OFF" position (ON). If you wish to
have dimming capability, you will need to use a
different type of bulb (sold separately) and the
switch must be moved to the "ON" position (DIM).
Select a faceplate (almond or white) and press
firmly onto front of wall control. Attach wall control
to outlet box and secure with screws from original
wall switch. Attach wall plate (included) to wall
control using 2 screws provided with the wall
control.
(wiring for wall control)
black (OUT to fan)
green
black
(AC IN from
breaker box)
black
(TO POWER supply)
black
green/
green/
bare
bare
ground
ground
green/
bare
ground
outlet box
wall control
face-
plate
12V battery
dimmer
switch
DIM ON
11
-
22
-
7. Canopy Assembly.
Locate 2 screws on underside of hanging
bracket and remove screw closest to the open
end of the hanging bracket. Partially loosen the
other screw. Lift canopy to hanging bracket.
Place rounded part of slotted hole in canopy
over loosened screw in hanging bracket and
push up. Twist canopy to lock. Re-insert screw
that was removed and then tighten both screws
securely.
Slide canopy cover up to canopy, aligning
rounded part of slotted holes in canopy cover
with screwheads in bottom of canopy. Turn
canopy cover to the right (clockwise) until it
stops.
*Remember that antenna for remote control
receiver must rest outside of hanging bracket.
canopy cover
screw
canopy
hanging bracket
screw
antenna
plate
WARNING: Choking Hazard - Small parts.
Keep battery away from children.
Loading ...
Loading ...
Loading ...