Loading ...
Loading ...
Loading ...
page 5
5. Fan Assembly. (cont.)
wood
ceiling
joist
safety cable
wood screw
and washer
safety cable loop
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your
fan. Grab the fan firmly with two hands. Slide downrod
through opening in hanging bracket and let hanging ball
rest on the hanging bracket. Turn the hanging ball slot
until it lines up with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
CAUTION: Due to the size (width) of this fan, it is advisable
to seek the help of another person to hold the stepladder
in place and to then help lift the fan up to you once you
are set on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be
necessary to use a heavy duty wood screw, washer and
lock washer (not supplied) with the safety cable loop. If
necessary, adjust the loop at the end of the safety cable.
The loop at the end of the safety cable should just fit over
the threads on the wood screw. Test safety cable by pulling
on loose end with pliers. If the safety cable slips, the loop
must be adjusted tighter. Extra cable slack can be left in
ceiling area.
motor
assembly
6. Wiring.
CAUTION: Be sure outlet box is properly grounded and
that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code (or
Canadian Electrical Code). If you are unfamiliar with
electrical wiring or if the house/building wires are
different colors than those referred to in the diagram to
the right, please use a qualified electrician.
When downrod is secured in place on the hanging
bracket, wire the RECEIVER with wire connectors
provided as shown in diagram at right.
Tip: While you are wiring, keep in mind that wires
must not obstruct receiver from sliding into hanging
bracket.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
Gently insert receiver (flat side up) into hanging
bracket and carefully push wires and taped wire
connectors into outlet box. Let antenna rest outside of
hanging bracket.
["Wiring" continued on next page.]
(wiring for receiver)
white supply wire
black supply wire
black
black
white
grey
blue
blue
grey
white
from receiver
black
AC IN L
AC IN N
white
white
ground (green
or bare)
from fan
from receiver
antenna
from ceiling
black
receiver
ground (green
or bare)
hanging ball slot
hanging bracket tab
Loading ...
Loading ...
Loading ...