Loading ...
Loading ...
© 2020 United States Stove Company
3
3. Stand the stove upright on its legs. The legs may be
adjusted to level the stove or compensate for uneven
ground.
4. Attach the two wire shelves to the sides of the fire
box by inserting the ends of the shelf into the tubes
on either side of the stove.
5. Installing the chimney pipe - Install the spark arrestor
over the top of one of the pipes. Secure the spark
arrestor to the pipe by tightening down the #10AB
X 1/2 screw. Then install this pipe into the wide end
of the next and so on until all six pipes are assembled
together. If using the stove in windy conditions pipe
clamps should be used to secure the pipes together
(pipe clamps not included). Once the chimney is
assembled lift the chimney up through the stove jack
in the tent and then install into the top of the stove.
Note: Depending on stove jack size some chimney
sections may need to be installed down through the
stove jack from the outside of the tent.
WARNING:
BEFORE USING THE STOVE THE FIRST TIME THE
PAINT MUST BE PROPERLY CURED.
CURING THE PAINT
Set your new stove up in your backyard or driveway and
burn wood in the stove for 1-2 hour to cure the paint. The
damper makes your stove 10-15% more ecient reducing
the amount of wood you have to cut by 10-15%.
WARNING:
KEEP ALL COMBUSTIBLE MATERIALS A MINIMUM
OF 3 FEET AWAY FROM THE STOVE. THIS
PREVENTS ANY FLAMMABLES FROM CATCHING
FIRE DUE TO THE STOVE HEAT, PREVENTS
SPARKS FROM POPPING THROUGH THE AIR
INTAKE OPENINGS AND CATCHING FLAMMABLES
ON FIRE AND ALSO IN CASE SPARKS POP OUT
WHEN YOU OPEN THE STOVE DOOR.
ASSEMBLY
Loading ...
Loading ...
Loading ...