Loading ...
Loading ...
Loading ...
24
INSTALLATION INSTRUCTIONS
4.5 The Dimension of the Unit
Unit:mm
Capacity
12-18
A
BDE
FGH
C
990660206505506907
200203
Note:The dimension of 12000Btu/h and
18000Btu/h are the same.
5. Floor and Standing Type
(Console)
5.1 Accessories(Console)
Please check whether the following fittings
are of full scope. If there are some spare
fittings, please restore them carefully.
SHAPE
QUANTITY
NAME
1.Hook
7. Owner's manual
8. Installation manual
3. Remote controller
4. Frame
6. Alkaline dry batteries
(AM4)
2
1
1
2
2
1
1
5. Mounting screw
(ST2.9
10-C-H)
Installation
fittings
Remote
controller
& Its Frame
Others
Cautions on remote controller installation:
Never throw or beat the controller.
Before installation, operate the remote
controller to determine its location in a
reception range.
Keep the remote controller at least 1m apart
from the nearest TV set or stereo equipment.
(it is necessary to prevent image
disturbances or noise interferences.)
Do not install the remote controller in a place
exposed to direct sunlight or close to a
heating source, such as a stove.
Note that the positive and negative poles
are right positions when loading batteries.
Remote
controller
Remote controller
holder
Mounting screw B
ST2.9x10-C-H
SET TEMPERATURE??
O
C)
AUTO
COOL
DRY
HEAT
FAN
HIGH
MED
LOW
TEMP.
MODE
ON/OFF
FAN SPEED
SWING
ECONOMIC
TIMER ON
RESET
LOCK
TIMER OFF
AIR DIRECTION
POWERFUL
Fig.50-1
5.2 Inspecting and Handling the
unit(Console)
5.3 Indoor Unit Installation(Console)
At delivery, the package should be
checked and any damage should be
reported immediately to the service agent.
When handling the unit, take into account
the following:
1. Fragile, handle the unit with care.
2. Keep the unit upright in order to
avoid compressor damage.
3. Choose on before hand the path along
which the unit is to be brought in.
4. Move this unit as originally package as
possible.
5. When lifting the unit , always use
protectors to prevent belt damage and
pay attention to the position of the
unit s centre of gravity.
,
5.3.1 Installation place
The indoor unit should be installed in a
location that meets the following
requirements:
There is enough room for installation and
maintenance.(Refer to Fig.50-2 & Fig.50-3)
The outlet and the inlet are not impeded,
and the influence of external air is the
least.
The air flow can reach throughout the
room.
The connecting pipe and drainpipe could
be extracted out easily.
There is no direct radiation from heaters.
.
This manual is subject to changes due to
technological improvement without
further notices.
2. Magnetic ring
(on
models)
some
1
Loading ...
Loading ...
Loading ...