Loading ...
Loading ...
Loading ...
Blower Motor Systems Installation
For recessed bottom cabinet only
If the cabinets have front, side or back trim, make 2
wood shims the width of the trim and attach them to
the cabinet bottom recess on both sides.
Installation to wall
(Horizontal duct- 31A"x10" Rectangular)
• Use the diagram or the hood as a template and
mark the locations on the wall for ductwork,
electrical wiring and keyhole screw slots.
View From
1" x6" Min.
Mounting
Support
1-3/16"
permanent
mounting hole /
WALL
13-5/6" (30" Hood)
16-13/16_'(36 ' Hood)
6-13/16"(30"Hood)
T'(36" Hood) _
/
Center line
13-5/6" (30' Hood)
4 16-13/16" (3e' Hood) I1_
1
6-13/16" (30"Hood)
7' (36" Hood) _'
_]1_\ \ permanent
(30" ModeE) _ \
(36" ModeE) mounting hole
Install framing for hood support
° Ifdrywall is present, mark the screw hole
locations. Remove the template.
° Cut away enough drywall to expose 2 vertical
studs at the holes location indicated by the
template. Install two horizontal supports at least
4" x 2" between two wall studs at the bottom and
upper mounting holes installation location.
° The horizontal support must be flush with the
room side of the studs. Use cleats behind both
sides of the support to secure to wall studs.
° Reinstall drywall and refinish.
IMPORTANT- Framing must be capable of supporting
100 Ibs.
• Cut holes at marked locations for duct and
electrical wiring.
• Forthe vertical duct, cut out 3A"extra toward the
front of the cabinet so you can move the duct
freely when installing the hood.
• Itmay also ease installation by cutting the hole
10W' instead of 10".
° Drive a mounting screw (from the hardware
packet) partway into each center of the narrow
neck of the keyhole slots marked on the cabinet
bottom.
° Fix the wiring conduit to the hood.
° Slide the hood back against the wall. Tighten the
mounting screws. Be sure the screw heads are in
the narrow neck of the keyhole slot.
° Connect Ductwork to hood.
Loading ...
Loading ...
Loading ...